Run Service Drive Tire Tread Depth and Wear Inspection Form — Free

Inspection Setup and Vehicle Identification

Vehicle identified and inspection date/time recorded

Record the inspection timestamp for the specific vehicle being evaluated.

Odometer reading recorded

Enter the current odometer reading to support service history and tire wear analysis.

Tire size and axle position confirmed

Document the tire size and the axle/position being inspected if needed for recommendation accuracy.

Inspection performed as part of multi-point service drive process

Confirm this tire check was completed during the service drive multi-point inspection workflow.

Yes No N/A

Tread depth gauge available and used for measurement critical (required)

Confirm a tread depth gauge was used rather than visual estimation.

Yes No N/A

Per-Tire Inflation Pressure Check

Front left tire pressure recorded

Measure and record the tire inflation pressure for the front left tire.

Note (optional)

Front right tire pressure recorded

Measure and record the tire inflation pressure for the front right tire.

Note (optional)

Rear left tire pressure recorded

Measure and record the tire inflation pressure for the rear left tire.

Note (optional)

Rear right tire pressure recorded

Measure and record the tire inflation pressure for the rear right tire.

Note (optional)

Any tire pressure below manufacturer specification critical (required)

Mark yes if any tire is below the vehicle placard or manufacturer-recommended inflation pressure.

Yes No N/A

Tread Depth Measurements

Front left tread depth critical (required)

Measure tread depth in 32nds of an inch at the primary wear points.

Front right tread depth critical (required)

Measure tread depth in 32nds of an inch at the primary wear points.

Rear left tread depth critical (required)

Measure tread depth in 32nds of an inch at the primary wear points.

Rear right tread depth critical (required)

Measure tread depth in 32nds of an inch at the primary wear points.

Minimum tread depth meets replacement threshold critical (required)

Confirm all inspected tires meet the shop's minimum tread depth threshold for continued service.

Yes No N/A

Wear Pattern and Tire Condition Assessment

Wear pattern is even across the tread

Check for even wear across the tread surface.

Yes No N/A

Inner shoulder wear observed

Identify abnormal wear on the inner shoulder that may indicate alignment or inflation issues.

Yes No N/A

Outer shoulder wear observed

Identify abnormal wear on the outer shoulder that may indicate alignment or cornering-related wear.

Yes No N/A

Cupping, scalloping, or feathering observed

Document irregular wear patterns that may indicate suspension, balance, or alignment concerns.

Yes No N/A

Sidewall damage, cuts, bulges, or exposed cords observed critical (required)

Inspect each tire for visible damage that may require immediate replacement.

Yes No N/A

Recommendation and Closeout

Tire rotation recommended

Indicate whether tire rotation is recommended based on wear pattern and service interval.

Yes No N/A

Alignment inspection recommended

Indicate whether alignment follow-up is recommended due to uneven or abnormal wear.

Yes No N/A

Tire replacement recommended critical (required)

Indicate whether one or more tires should be replaced based on tread depth, damage, or wear pattern.

Yes No N/A

Inspector comments

Summarize the overall tire condition, measurements, and recommended next steps.

Get your results

Enter your email — we'll send you a PDF of your filled-out template, plus the occasional MangoScoop newsletter (templates, workflow tips, product updates). Unsubscribe anytime — link is in every email.

Email (required)

Your name (optional)

Run: Service Drive Tire Tread Depth and Wear Inspection Form

Inspection Setup and Vehicle Identification

Per-Tire Inflation Pressure Check

Tread Depth Measurements

Wear Pattern and Tire Condition Assessment

Recommendation and Closeout

Get your results