Run Protective Relay Calibration and Functional Test Inspection — Free

Inspection Details

Inspection date and time recorded

Facility, switchgear lineup, or test location identified

Relay make, model, and serial number documented

Applicable coordination study or settings sheet referenced

Test type selected

Safety Preconditions and Test Readiness

Lockout-tagout applied where required and test boundaries established critical (required)

Yes No N/A

Qualified person or competent person performing the test critical (required)

Yes No N/A

Arc-flash and shock PPE selected per job hazard analysis critical (required)

Yes No N/A

Test equipment calibrated and within current certification date critical (required)

Yes No N/A

Primary and secondary injection setup verified against the test plan

Yes No N/A

Relay Identification and Visual Condition

Relay identification matches the one-line diagram and test plan critical (required)

Yes No N/A

Control power, CT, and VT wiring labels are present and legible

Yes No N/A

Terminal blocks, covers, and seals intact with no visible damage

Yes No N/A

No signs of overheating, contamination, loose connections, or moisture intrusion

Yes No N/A

Relay target indicators, LEDs, and event flags cleared or documented before test

Yes No N/A

Pickup and Timing Verification

Phase overcurrent pickup verified against settings critical (required)

Ground fault pickup verified against settings critical (required)

Measured trip time for primary protection element critical (required)

Measured timing is within coordination study tolerance critical (required)

Yes No N/A

Trip output operated the intended breaker or trip circuit critical (required)

Yes No N/A

As-Left Settings and Functional Trip Verification

As-left pickup settings match the approved coordination study critical (required)

Yes No N/A

Time dial, curve, and logic settings match the approved test record critical (required)

Yes No N/A

Trip circuit continuity and breaker trip coil operation verified critical (required)

Yes No N/A

Protection scheme operated as intended during functional test critical (required)

Yes No N/A

Test results and as-left values documented in the final report

Yes No N/A

Deficiencies, Corrective Actions, and Sign-Off

Deficiencies or non-conformances recorded

Corrective actions assigned with responsible party and due date

Inspector signature critical (required)

Get your results

Enter your email — we'll send you a PDF of your filled-out template, plus the occasional MangoScoop newsletter (templates, workflow tips, product updates). Unsubscribe anytime — link is in every email.

Email (required)

Your name (optional)

Run: Protective Relay Calibration and Functional Test Inspection

Inspection Details

Safety Preconditions and Test Readiness

Relay Identification and Visual Condition

Pickup and Timing Verification

As-Left Settings and Functional Trip Verification

Deficiencies, Corrective Actions, and Sign-Off

Get your results