Run Preform and Container Wall Thickness Measurement Log — Free

Inspection Details

Inspection date and time recorded critical (required)

Product type identified critical (required)

Lot, batch, or run number recorded critical (required)

Measurement standard or SOP referenced

Enter the internal specification, drawing number, or SOP used for this inspection.

Inspector name and signature completed critical (required)

Sample and Setup Verification

Sample count matches inspection plan critical (required)

Measurement tool identified and verified critical (required)

Record the caliper, ultrasonic gauge, micrometer, or other approved instrument used.

Measurement tool within calibration date critical (required)

Yes No N/A

Parts conditioned to inspection temperature

Confirm parts were stabilized per SOP before measurement to reduce thermal variation.

Yes No N/A

Defined measurement points available and understood critical (required)

Confirm the inspector has the correct measurement map for neck, shoulder, body, base, or other defined points.

Yes No N/A

Wall Thickness Measurements

Neck or finish thickness within tolerance critical (required)

Record the measured thickness at the neck or finish measurement point.

Shoulder thickness within tolerance critical (required)

Record the measured thickness at the shoulder measurement point.

Body thickness within tolerance critical (required)

Record the measured thickness at the body or sidewall measurement point.

Base or heel thickness within tolerance critical (required)

Record the measured thickness at the base or heel measurement point.

Minimum wall thickness meets specification critical (required)

Enter the thinnest measured point from the sample set and compare it to the minimum acceptable thickness.

Material Distribution and Defect Review

Wall thickness variation is within allowable range critical (required)

Confirm thickness variation across defined points does not exceed the product specification or control limit.

Yes No N/A

Thin spots, sink marks, or localized thinning observed critical (required)

Mark Yes only if a defect is present. Any localized thinning is a non-conformance requiring review.

Yes No N/A

Flash, warpage, or deformation affecting measurement

Identify any condition that could distort the reading or indicate molding instability.

Yes No N/A

Surface damage or contamination affecting inspection

Note scratches, contamination, or handling damage that may affect measurement accuracy or part acceptability.

Yes No N/A

Disposition and Closeout

Inspection result critical (required)

Corrective action or disposition documented

Record rework, segregation, engineering review, or other disposition if any measurement is out of tolerance.

Supervisor or quality reviewer approval

Get your results

Enter your email — we'll send you a PDF of your filled-out template, plus the occasional MangoScoop newsletter (templates, workflow tips, product updates). Unsubscribe anytime — link is in every email.

Email (required)

Your name (optional)

Run: Preform and Container Wall Thickness Measurement Log

Inspection Details

Sample and Setup Verification

Wall Thickness Measurements

Material Distribution and Defect Review

Disposition and Closeout

Get your results