Run Paint Thickness and Mil Gauge Calibration Log — Free

Inspection Details

Inspection date and time recorded

Inspector name or ID recorded

Gauge identification number recorded

Gauge model and serial number recorded

Calibration standard or reference block identified

Instrument Condition and Setup

Gauge powers on and displays no error codes critical (required)

Yes No N/A

Probe tip and body are clean, dry, and free of visible damage critical (required)

Yes No N/A

Photo evidence (optional)

Battery level is adequate for the inspection

Yes No N/A

Ambient conditions are suitable for measurement

Verify the work area is free of excessive dust, moisture, vibration, or temperature extremes that could affect readings.

Yes No N/A

Gauge zeroed or reset per manufacturer instructions before verification critical (required)

Yes No N/A

Calibration Verification

Calibration verification performed against known standard critical (required)

Yes No N/A

Measured reading is within acceptable tolerance of standard critical (required)

Record the measured thickness value from the gauge during verification.

Reference standard nominal thickness

Enter the nominal thickness of the calibration standard used for verification.

Measured deviation from standard recorded

Record the difference between the gauge reading and the nominal standard value.

Gauge passes repeatability check across multiple readings critical (required)

Yes No N/A

Measurement Readiness and Documentation

Gauge is approved for use on coating thickness measurements critical (required)

Yes No N/A

Any out-of-calibration condition documented

Yes No N/A

Corrective action taken or escalation recorded

Next calibration due date recorded

Closeout and Sign-Off

Inspection results reviewed and accepted critical (required)

Yes No N/A

Inspector signature critical (required)

Supervisor or QA review completed when required

Yes No N/A

Get your results

Enter your email — we'll send you a PDF of your filled-out template, plus the occasional MangoScoop newsletter (templates, workflow tips, product updates). Unsubscribe anytime — link is in every email.

Email (required)

Your name (optional)

Run: Paint Thickness and Mil Gauge Calibration Log

Inspection Details

Instrument Condition and Setup

Calibration Verification

Measurement Readiness and Documentation

Closeout and Sign-Off

Get your results