Tire Mounting Bay Pre-Shift Equipment Inspection

Pre-shift inspection template for tire mounting bay equipment, controls, guarding, and work area readiness before tire changer operation.

Inspection Setup and Operator Readiness

• Inspector identifies bay, date, shift, and equipment ID
  Record the tire mounting bay location, inspection date, shift, and tire changer or mounting equipment asset ID.
• Operator is trained and authorized for tire changer use
  Verify the operator is trained, authorized, and familiar with the manufacturer's operating instructions and shop procedures.
• Required PPE available and worn
  Confirm appropriate PPE is in use for the task, such as safety glasses, hearing protection if required, safety footwear, and gloves as specified by site procedure.

Pre-Use Visual Condition Check

• Tire changer frame, mounts, and fasteners show no visible damage
  Inspect the machine frame, base, mounting points, and visible fasteners for cracks, deformation, looseness, or missing hardware.
• Air lines, hydraulic lines, and electrical cords are intact and routed safely
  Check for cuts, abrasion, leaks, exposed conductors, damaged fittings, or trip hazards. Verify cords and hoses are not pinched or routed through traffic paths.
• Guards, shields, and safety covers are in place
  Confirm all manufacturer-required guards, shields, and covers are installed and secure before operation.
• Lubrication, leaks, and contamination around the machine are acceptable
  Look for oil, air, hydraulic, or grease leaks; excessive debris; and contamination that could affect safe operation or create slip hazards.

Operational Controls and Safety Devices

• Emergency stop and power disconnect function correctly
  Verify the emergency stop is accessible and the machine can be de-energized using the normal disconnect or shutoff control.
• Pedals, clamps, bead breaker, and rotation controls operate smoothly
  Test controls for normal response, sticking, delayed movement, unusual noise, or uncontrolled motion. Do not use the machine if controls are erratic.
• Air pressure is within the manufacturer-specified operating range
  Record the measured supply pressure and confirm it is within the equipment manufacturer's specified range.
• Safety interlocks and restraint features are functional
  Verify any machine interlocks, wheel restraint features, or bead seating safety devices operate as intended per the manufacturer's instructions.

Work Area, Housekeeping, and Fire Safety

• Floor around the bay is clean, dry, and free of slip/trip hazards
  Inspect the immediate work area for spills, loose tools, cords, debris, and other obstructions that could affect safe movement around the tire changer.
• Compressed air hoses, tools, and accessories are stored safely
  Verify hoses, hand tools, valve tools, bead lubricant, and accessories are organized and do not create pinch, strike, or trip hazards.
• Fire extinguisher is present, accessible, and inspection current
  Confirm a suitable extinguisher is mounted, unobstructed, and within its inspection interval per site fire safety procedure and applicable NFPA requirements.