Splice and Termination Verification Log

Inspection log for medium- and low-voltage cable splices and terminations documenting kit type, conductor identification, torque values, workmanship checks, and inspector sign-off to support OSHA and NFPA compliance.

Inspection Identification

• Inspection date and time recorded
• Work location, panel, vault, or equipment identified
• Circuit, feeder, or cable ID documented
• Voltage class identified
• Inspector name and company recorded
• Reference drawing, work order, or permit number

Splice and Termination Materials

• Kit type matches approved application and voltage class
• Kit part number and lot or batch number recorded
• Conductor size and insulation type match kit rating
• Lugs, connectors, and compression components are correct for the conductor
• Consumables, sealants, and stress-control materials are present and within shelf life

Torque and Connection Verification

• Specified torque value documented for each bolted connection
• Measured torque value documented for each bolted connection
• Measured torque meets specified torque within tolerance
• All connector set screws, lugs, and hardware are fully seated and secured
• Anti-oxidant compound, if required, was applied per manufacturer instructions

Workmanship and Installation Condition

• Cable jacket, insulation, and shielding are intact with no visible damage
• Splice or termination is properly aligned, supported, and strain relieved
• Insulation clearance, creepage, and spacing appear compliant with kit instructions
• Environmental conditions were suitable during installation
• Foreign material, moisture, contamination, or debris present at connection area

Testing, Sign-Off, and Corrective Action

• Insulation resistance or continuity test results documented, if required by scope
• Deficiencies or non-conformances recorded with corrective action
• Inspector sign-off completed
• Work released for service