Sanding Dust Extraction and Downdraft Table Inspection

Inspection template for body shop and prep area equipment managers to verify dust extraction performance, downdraft table airflow, filter condition, and housekeeping before sanding and grinding work.

Inspection Setup and Area Identification

• Inspection date and time recorded
• Downdraft table or dust extraction unit identified by asset ID or location
• Area is accessible and free of active work that would prevent a safe inspection
• Inspector has reviewed the applicable SOP or maintenance checklist

Dust Extraction System Condition

• Dust collector housing, ducting, and connections are intact with no visible damage or loose fittings
• No visible dust leakage at seams, access doors, or hose connections
• Collection bin, drawer, or disposal container is properly seated and not overfilled
• System indicators show normal operation with no alarm, fault, or overload condition
• Access panels and service doors are closed and secured

Downdraft Table Airflow and Capture Performance

• Airflow at the downdraft table is present and uniform across the work surface
• Measured face velocity or table airflow is within the manufacturer's acceptable range
• Dust is being captured at the source during a brief test sanding or airflow check
• Work surface openings, grates, and plenums are not blocked by tools, parts, or debris
• No unusual vibration, noise, or airflow pulsation is observed during operation

Filters and Maintenance Condition

• Primary filters are installed correctly and seated without bypass gaps
• Filters show no visible excessive loading, tearing, collapse, or moisture damage
• Differential pressure or filter restriction reading is within the acceptable operating range
• Filter change or cleaning is current per maintenance schedule

Housekeeping, Fire Risk, and Corrective Actions

• Accumulated sanding dust is removed from the table, floor, and nearby surfaces
• No ignition sources, hot work, or open flames are present in the dust collection area
• Any deficiency, non-conformance, or repair need is documented with an owner and due date
• Inspector signature