Press Brake Setup Sheet and First-Bend Verification

Inspection template for confirming press brake setup against the setup sheet before production, including punch and die selection, backgauge position, trial bend angle, springback control, and first-piece dimensional accuracy.

Job and Setup Sheet Identification

• Job number, part number, and revision match the setup sheet
• Material type, thickness, and grain direction match the setup sheet
• Required bend sequence and bend direction are understood and available
• Setup sheet, drawing, and bend allowance information are at the machine

Tooling and Machine Setup Verification

• Punch selection matches the setup sheet
• Die selection matches the setup sheet
• Punch and die are properly seated, aligned, and secured
• Backgauge position matches the setup sheet
• Ram depth / bend program setting matches the setup sheet
• Tooling clearance is adequate for part geometry and bend sequence

Trial Bend and First-Bend Verification

• Trial bend completed using the correct material orientation and bend sequence
• First-bend angle measured
• Target bend angle from setup sheet
• Springback compensation is acceptable for the measured material and tooling
• First-bend flange or leg dimensions meet drawing requirements
• Part orientation after bend matches the setup sheet and drawing

Approval, Non-Conformance, and Release

• Any setup deviation or non-conformance documented
• Corrective action completed and rechecked after any adjustment
• First-bend sample approved for production release
• Inspector or setup technician signature