Film Tensile and Elongation Test Record

Records tensile strength and elongation results for film and laminate samples and verifies the measured mechanical properties meet the material specification.

Inspection Details

• Test record identifier
  Unique record, batch, or report number for traceability.
• Sample identification
  Material name, grade, lot number, roll number, or laminate ID.
• Test date and time
  Date and time the tensile test was performed.
• Inspector or tester name
  Person performing the test and recording results.
• Applicable specification or method
  Internal material specification, customer requirement, or test method reference such as ASTM D882.

Sample and Test Setup

• Material type verified
  Confirm whether the sample is film, laminate, or other approved flexible sheet material.
• Specimen dimensions recorded
  Record specimen width, thickness, gauge length, and number of specimens tested.
• Conditioning environment recorded
  Record conditioning temperature and relative humidity used before testing, if applicable.
• Test equipment and calibration status
  Record the tensile tester, load cell, grips, and current calibration status.
• Specimen alignment and grip condition acceptable
  Specimens are centered, grips are secure, and no visible slippage or jaw damage is present before testing.

Tensile Test Results

• Tensile strength at break
  Maximum tensile strength measured at failure.
• Elongation at break
  Percent elongation measured at specimen break.
• Average tensile strength
  Average tensile strength across all valid specimens tested.
• Average elongation
  Average elongation across all valid specimens tested.
• Failure mode observed
  Record how the specimen failed during testing.

Acceptance and Non-Conformance

• Tensile strength meets specification
  Measured tensile strength is within the approved specification limits.
• Elongation meets specification
  Measured elongation is within the approved specification limits.
• Any non-conformance identified
  Record whether any out-of-spec result, equipment issue, or abnormal test condition was observed.

Review and Sign-Off

• Results reviewed against material specification
  Reviewer confirms the reported results were compared to the current material specification and acceptance criteria.
• Corrective action or disposition documented
  If any result failed, document containment, re-test, hold, reject, or other disposition.
• Inspector signature
  Signature confirming the record is complete and accurate.