Templates › Inspections › SEO page

Run: Film Tensile and Elongation Test Record

Record tensile strength and elongation results for film and laminate samples, then compare them to the material specification in one traceable test record. U...

Fill this out, get a PDF emailed to you. No account required. Want to run it with your team and track results? Sign up free →

Inspection Details

Test record identifier critical (required)

Unique record, batch, or report number for traceability.

Sample identification critical (required)

Material name, grade, lot number, roll number, or laminate ID.

Test date and time critical (required)

Date and time the tensile test was performed.

Inspector or tester name critical (required)

Person performing the test and recording results.

Applicable specification or method critical (required)

Internal material specification, customer requirement, or test method reference such as ASTM D882.

Sample and Test Setup

Material type verified critical (required)

Confirm whether the sample is film, laminate, or other approved flexible sheet material.

Specimen dimensions recorded critical (required)

Record specimen width, thickness, gauge length, and number of specimens tested.

Conditioning environment recorded

Record conditioning temperature and relative humidity used before testing, if applicable.

Test equipment and calibration status critical (required)

Record the tensile tester, load cell, grips, and current calibration status.

Specimen alignment and grip condition acceptable critical (required)

Specimens are centered, grips are secure, and no visible slippage or jaw damage is present before testing.

Yes No N/A

Tensile Test Results

Tensile strength at break critical (required)

Maximum tensile strength measured at failure.

Note (optional)

Elongation at break critical (required)

Percent elongation measured at specimen break.

Note (optional)

Average tensile strength

Average tensile strength across all valid specimens tested.

Average elongation

Average elongation across all valid specimens tested.

Failure mode observed

Record how the specimen failed during testing.

Note (optional)

Acceptance and Non-Conformance

Tensile strength meets specification critical (required)

Measured tensile strength is within the approved specification limits.

Yes No N/A

Elongation meets specification critical (required)

Measured elongation is within the approved specification limits.

Yes No N/A

Any non-conformance identified

Record whether any out-of-spec result, equipment issue, or abnormal test condition was observed.

Yes No N/A

Review and Sign-Off

Results reviewed against material specification critical (required)

Reviewer confirms the reported results were compared to the current material specification and acceptance criteria.

Yes No N/A

Corrective action or disposition documented

If any result failed, document containment, re-test, hold, reject, or other disposition.

Inspector signature critical (required)

Signature confirming the record is complete and accurate.

Get your results

Enter your email — we'll send you a PDF of your filled-out template, plus the occasional MangoScoop newsletter (templates, workflow tips, product updates). Unsubscribe anytime — link is in every email.

Email (required)

Your name (optional)

Generated with MangoApps Templates — browse 250+ free