Bag Dimension and Seal Width Check

Inspection template for verifying finished bag length, width, gusset, and seal width against the customer drawing and confirming dimensional tolerance.

Inspection Details

• Customer drawing or approved specification available
  Confirm the current customer drawing, revision, or approved specification is present at the inspection point.
• Lot, order, and revision identified
  Record the lot number, work order, product code, and drawing revision used for this inspection.
• Inspection date and time
  Record when the dimensional inspection was performed.
• Inspector name or ID
  Enter the inspector's name, badge number, or employee ID.
• Measurement tools verified and within calibration
  Confirm the measuring device used for length, width, gusset, and seal width checks is suitable and within calibration.

Dimensional Verification

• Bag length within customer tolerance
  Measure finished bag length and compare it to the approved drawing tolerance.
• Bag width within customer tolerance
  Measure finished bag width and compare it to the approved drawing tolerance.
• Gusset depth within customer tolerance
  Measure gusset depth and verify it matches the approved drawing.
• Seal width within customer tolerance
  Measure the finished seal width and verify it meets the customer drawing requirement.

Seal Integrity and Bag Condition

• Seals are continuous and free of visible gaps
  Inspect the seal area for continuity, breaks, skips, or open sections.
• Seal area free of burn-through, wrinkles, or contamination
  Check the seal zone for defects that could reduce seal performance or dimensional consistency.
• Bag edges and corners are uniform
  Verify the finished bag edges and corners are consistent with the approved sample and do not show distortion affecting dimensions.
• No visible damage affecting dimensions
  Confirm there are no tears, splits, punctures, or deformation that would affect the measured dimensions or usability.

Sampling, Results, and Disposition

• Sample size recorded
  Record the number of bags inspected from the lot.
• Inspection result
  Select the overall result for this lot or sample set.
• Non-conformance or corrective action notes
  Document any out-of-tolerance measurements, suspected root cause, containment action, or disposition decision.
• Inspector signature
  Inspector signs to confirm the measurements and results are accurate.