Run Bag Dimension and Seal Width Check — Free

Inspection Details

Customer drawing or approved specification available critical (required)

Confirm the current customer drawing, revision, or approved specification is present at the inspection point.

Yes No N/A

Lot, order, and revision identified

Record the lot number, work order, product code, and drawing revision used for this inspection.

Inspection date and time

Record when the dimensional inspection was performed.

Inspector name or ID

Enter the inspector's name, badge number, or employee ID.

Measurement tools verified and within calibration critical (required)

Confirm the measuring device used for length, width, gusset, and seal width checks is suitable and within calibration.

Yes No N/A

Dimensional Verification

Bag length within customer tolerance critical (required)

Measure finished bag length and compare it to the approved drawing tolerance.

Bag width within customer tolerance critical (required)

Measure finished bag width and compare it to the approved drawing tolerance.

Gusset depth within customer tolerance critical (required)

Measure gusset depth and verify it matches the approved drawing.

Seal width within customer tolerance critical (required)

Measure the finished seal width and verify it meets the customer drawing requirement.

Seal Integrity and Bag Condition

Seals are continuous and free of visible gaps critical (required)

Inspect the seal area for continuity, breaks, skips, or open sections.

Yes No N/A

Seal area free of burn-through, wrinkles, or contamination

Check the seal zone for defects that could reduce seal performance or dimensional consistency.

Yes No N/A

Bag edges and corners are uniform

Verify the finished bag edges and corners are consistent with the approved sample and do not show distortion affecting dimensions.

Yes No N/A

No visible damage affecting dimensions critical (required)

Confirm there are no tears, splits, punctures, or deformation that would affect the measured dimensions or usability.

Yes No N/A

Sampling, Results, and Disposition

Sample size recorded

Record the number of bags inspected from the lot.

Inspection result critical (required)

Select the overall result for this lot or sample set.

Note (optional)

Non-conformance or corrective action notes

Document any out-of-tolerance measurements, suspected root cause, containment action, or disposition decision.

Inspector signature

Inspector signs to confirm the measurements and results are accurate.

Get your results

Enter your email — we'll send you a PDF of your filled-out template, plus the occasional MangoScoop newsletter (templates, workflow tips, product updates). Unsubscribe anytime — link is in every email.

Email (required)

Your name (optional)

Run: Bag Dimension and Seal Width Check

Inspection Details

Dimensional Verification

Seal Integrity and Bag Condition

Sampling, Results, and Disposition

Get your results