ADAS Calibration Prerequisite Verification Sheet

Inspection template for collision repair technicians to verify vehicle and bay prerequisites before performing ADAS calibration, including tire pressure, fuel level, ride height, floor levelness, target distances, and OEM-specific setup requirements.

Inspection Details

• Repair order number recorded
• Vehicle year, make, model, and VIN recorded
• Calibration type identified

OEM Procedure and Documentation

• OEM calibration procedure reviewed before setup
  Verify the current OEM procedure or service information was reviewed for this vehicle and calibration event.
• Required special tools, targets, and scan tools available
  Confirm all OEM-specified targets, fixtures, scan tools, and accessories are present and serviceable.
• Vehicle not modified in a way that affects calibration prerequisites
  Confirm no unresolved suspension, wheel, tire, ride height, steering, or body condition exists that would invalidate calibration setup.

Vehicle Setup Conditions

• Tire pressures set to OEM specification
• Fuel level within OEM-required range
• Ride height within OEM specification
• Vehicle loaded condition matches OEM requirement
  Verify required cargo, ballast, occupants, or empty-vehicle condition is set per OEM procedure.
• Suspension and steering components visually verified as complete and secure
  Confirm no obvious looseness, missing fasteners, or unresolved damage that would affect calibration geometry.

Calibration Bay and Environmental Conditions

• Floor levelness within OEM tolerance
• Calibration area clear of obstructions and reflective interference
  Verify the target path, sensor line of sight, and working area are free of tools, carts, people, glare sources, and other interference.
• Lighting conditions meet OEM requirements
  Confirm ambient and task lighting are within the OEM procedure for the calibration being performed.
• Wheel alignment rack or bay setup verified for calibration use
  Confirm the vehicle is positioned on the correct surface and equipment, with any required turn plates or slip plates installed and released.
• Target distances and centerline measurements set per OEM

Final Readiness and Sign-Off

• All prerequisite checks completed with no unresolved deficiencies
  Use this item only when every required prerequisite has been verified and any out-of-spec condition has been corrected or escalated.
• Corrective actions documented for any failed prerequisite
• Inspector signature