Run Window Screen Assembly Inspection — Free

Inspection Identification

Screen model / size recorded

Record the product model, nominal size, or work order identifier for the screen being inspected.

Inspection stage confirmed as pre-pack

Confirm the screen is being inspected after assembly and before packing.

Inspector name recorded

Enter the name or ID of the inspector performing the check.

Inspection date and time recorded

Capture when the inspection was completed.

Reference work order or batch number recorded

Record the work order, lot, or batch number for traceability.

Frame Geometry and Assembly

Frame is square within specification critical (required)

Check that opposite corners and diagonals indicate a square frame within the approved tolerance.

Yes No N/A

Corner joints are fully seated and aligned critical (required)

Verify all corners are tight, flush, and free of gaps, twist, or separation.

Yes No N/A

Frame members are straight with no visible bowing

Inspect the frame rails for warping, bending, or distortion that could affect fit or appearance.

Yes No N/A

Frame surface is free of dents, scratches, or burrs affecting fit

Check for damage that could interfere with installation, handling, or customer acceptance.

Yes No N/A

Overall frame dimensions match the work order critical (required)

Confirm the assembled screen matches the specified size and does not show obvious oversize or undersize condition.

Yes No N/A

Spline Seating and Mesh Tension

Spline is fully seated in the channel critical (required)

Verify the spline is continuous and fully pressed into the groove around the perimeter with no lift-out or gaps.

Yes No N/A

Mesh tension is even across the full screen critical (required)

Check that the mesh is taut and uniform from corner to corner without localized slack.

Yes No N/A

Mesh is free of wrinkles, waves, or sagging critical (required)

Inspect the visible mesh surface for loose areas, ripples, or deformation that would be visible after installation.

Yes No N/A

Mesh is centered and evenly trimmed at the perimeter

Confirm the mesh overlaps are consistent and there is no excessive overhang, pullback, or exposed edge condition.

Yes No N/A

No tears, punctures, or broken strands in mesh critical (required)

Inspect the screen surface for damage, holes, or broken filaments that would reduce function or appearance.

Yes No N/A

Final Appearance and Packing Readiness

Screen is clean and free of debris

Check for dust, metal shavings, adhesive residue, or other contamination on the frame or mesh.

Yes No N/A

No loose components or unfinished fasteners present critical (required)

Verify there are no loose clips, protruding ends, or unfinished assembly elements that could detach in handling.

Yes No N/A

Screen fits the intended packaging or handling standard

Confirm the screen can be packed without interference, damage risk, or special handling due to assembly defects.

Yes No N/A

Defects documented with photo evidence when present

Capture photos of any non-conformance, including loose mesh, wrinkling, spline issues, or frame defects.

Disposition selected for failed screens

Choose the disposition if any defect is found.

Note (optional)

Get your results

Enter your email — we'll send you a PDF of your filled-out template, plus the occasional MangoScoop newsletter (templates, workflow tips, product updates). Unsubscribe anytime — link is in every email.

Email (required)

Your name (optional)

Run: Window Screen Assembly Inspection

Inspection Identification

Frame Geometry and Assembly

Spline Seating and Mesh Tension

Final Appearance and Packing Readiness

Get your results