Templates › Inspections › SEO page

Run: Weatherstripping Installation Verification

Verify that the installed weatherstrip matches the approved door specification, seats correctly, and seals the full perimeter without interfering with door o...

Fill this out, get a PDF emailed to you. No account required. Want to run it with your team and track results? Sign up free →

Inspection Identification

Door and job identification recorded

Record the door number, job/order number, location, and inspection date.

Weatherstrip specification or BOM reference available

Document the approved weatherstrip type, profile, finish, and reference document used for verification.

Inspector identified

Enter the name or ID of the inspector completing the verification.

Inspection stage confirmed as assembled door QC critical (required)

Confirm the door is fully assembled and ready for final QC verification.

Yes No N/A

Weatherstrip Type and Installation

Installed weatherstrip matches approved specification critical (required)

Verify the installed weatherstrip type, profile, and material match the approved specification and have not been substituted or modified.

Yes No N/A

Photo evidence (optional)

Weatherstrip is fully seated in the intended retainer or kerf critical (required)

Check that the weatherstrip is properly inserted, seated, and retained without lifting, twisting, or partial engagement.

Yes No N/A

Photo evidence (optional)

No visible cuts, tears, deformation, or damage critical (required)

Inspect the installed weatherstrip for physical damage, compression set, splits, or other defects that could affect sealing performance.

Yes No N/A

Photo evidence (optional)

Continuity and Seal Coverage

Weatherstrip continuity is complete around required perimeter critical (required)

Verify continuous coverage at all required contact edges with no missing sections, breaks, or open joints.

Yes No N/A

Photo evidence (optional)

Corners, joints, and end conditions are properly joined critical (required)

Check that corners and splice points are cleanly joined and do not create gaps, overlaps, or discontinuities in the seal line.

Yes No N/A

Photo evidence (optional)

Compression and contact appear uniform along the seal line

Rate the uniformity of weatherstrip contact against the mating surface across the full perimeter.

Door Fit and Functional Check

Door closes and latches without binding on weatherstrip critical (required)

Confirm the door closes fully and latches properly without excessive force, drag, or interference from the weatherstrip.

Yes No N/A

Visible gap or light leakage at perimeter is within acceptable limit

Measure any visible perimeter gap where applicable and record the result.

Photo evidence (optional)

Note (optional)

Weatherstrip does not interfere with hinges, hardware, or thresholds critical (required)

Verify the seal does not obstruct hinges, latches, closers, astragals, thresholds, or other installed hardware.

Yes No N/A

Compliance, Deficiencies, and Sign-Off

Fire-rated assembly requirements considered where applicable critical (required)

If the door is fire-rated, confirm the weatherstripping installation does not modify the listed assembly and remains consistent with the approved fire door components and AHJ requirements. Reference NFPA 80 where applicable.

Yes No N/A

Deficiencies documented with corrective action

List any non-conformances, including missing sections, misalignment, damaged material, or rework required.

Inspector signature

Inspector signs to confirm the verification was completed accurately.

Get your results

Enter your email — we'll send you a PDF of your filled-out template, plus the occasional MangoScoop newsletter (templates, workflow tips, product updates). Unsubscribe anytime — link is in every email.

Email (required)

Your name (optional)

Generated with MangoApps Templates — browse 250+ free