Run Spacer Bar Application and Desiccant Fill Inspection — Free

Inspection Setup and Run Identification

Run, line, and product identification recorded critical (required)

Inspection performed at the correct IG assembly stage critical (required)

Spacer bar and desiccant materials match the approved specification critical (required)

Yes No N/A

Spacer Bar Bend Quality and Fit

Spacer bar bend quality is smooth and free of kinks, flattening, or distortion critical (required)

Yes No N/A

Photo evidence (optional)

Spacer bar dimensions and corner geometry match the frame pattern critical (required)

Yes No N/A

Spacer bar sits flush with no visible gaps at contact points critical (required)

Yes No N/A

Photo evidence (optional)

Spacer bar surface is free of damage, contamination, or deformation that could affect sealing critical (required)

Yes No N/A

Measured spacer bar fit within acceptable tolerance

Record the measured gap, deviation, or fit error in millimeters. Use the approved work instruction for the exact tolerance limit.

Corner Keys and Splice Joints

Corner keys are fully seated and properly aligned critical (required)

Yes No N/A

Photo evidence (optional)

Corner joints are tight with no visible separation or misalignment critical (required)

Yes No N/A

Splice joints are secure and continuous without openings or step changes critical (required)

Yes No N/A

Photo evidence (optional)

Joint areas are free of burrs, cracks, or other non-conformances

Yes No N/A

Approved adhesive, sealant, or fastening method applied per specification critical (required)

Yes No N/A

Desiccant Fill Verification

Active desiccant quantity meets the specified fill requirement critical (required)

Enter the percent of required fill achieved for the spacer bar cavity or the measured quantity per the approved specification.

Desiccant is active, dry, and free-flowing at time of fill critical (required)

Yes No N/A

Desiccant fill is continuous with no voids, bridging, or overfill at corners critical (required)

Yes No N/A

Photo evidence (optional)

Fill ports or openings are properly closed after desiccant loading critical (required)

Yes No N/A

Defects, Corrective Action, and Release

Deficiencies or non-conformances documented with location and description

Corrective action assigned and verified before release critical (required)

Yes No N/A

Inspector release authorization completed critical (required)

Get your results

Enter your email — we'll send you a PDF of your filled-out template, plus the occasional MangoScoop newsletter (templates, workflow tips, product updates). Unsubscribe anytime — link is in every email.

Email (required)

Your name (optional)

Run: Spacer Bar Application and Desiccant Fill Inspection

Inspection Setup and Run Identification

Spacer Bar Bend Quality and Fit

Corner Keys and Splice Joints

Desiccant Fill Verification

Defects, Corrective Action, and Release

Get your results