Templates › Inspections › SEO page

Run: Partial Discharge Test - Solid Dielectric Module

Record partial discharge readings for epoxy-encapsulated and solid dielectric switchgear modules, with setup, measurement, defects, and sign-off captured in ...

Fill this out, get a PDF emailed to you. No account required. Want to run it with your team and track results? Sign up free →

Test Identification and Scope

Module identification recorded

Record the module serial number, part number, voltage class, and test station identifier.

Test type confirmed as routine partial discharge test critical (required)

Confirm this is a 100 percent routine test on a cast solid dielectric or epoxy-encapsulated module.

Yes No N/A

Test standard or procedure referenced

Enter the applicable internal procedure, customer specification, or test method reference used for this inspection.

Safety Preconditions and Test Setup

Lockout-tagout applied where required critical (required)

Verify the test article and associated circuits are de-energized and controlled per site lockout-tagout procedure.

Yes No N/A

Work area controlled and access restricted critical (required)

Confirm barriers, signage, and access control are in place to keep unauthorized personnel clear of the test area.

Yes No N/A

Required PPE worn critical (required)

Select all PPE used for the test setup and measurement activity.

Test equipment calibration current critical (required)

Confirm the partial discharge detector, sensors, and any coupling or measurement accessories are within calibration date.

Yes No N/A

Environmental and Instrument Conditions

Ambient temperature

Record ambient temperature at the test location.

Relative humidity

Record relative humidity at the test location.

Background noise or interference acceptable critical (required)

Confirm the electromagnetic or acoustic background level does not prevent reliable partial discharge measurement.

Yes No N/A

Measurement method selected critical (required)

Select the partial discharge detection method used for this test.

Partial Discharge Measurements

Test voltage applied critical (required)

Record the applied test voltage during the measurement.

Measured partial discharge level critical (required)

Record the measured partial discharge magnitude at the specified test point.

Measurement location or test point

Identify the module, phase, bushing, termination, or other location where the reading was taken.

Repeat reading stable critical (required)

Confirm the reading is repeatable and not caused by transient interference or setup instability.

Yes No N/A

Defects, Findings, and Disposition

Evidence of voids, cracks, or insulation defects observed critical (required)

Record whether the test or visual review identified signs of voids, cracks, delamination, tracking, or other insulation anomalies.

Yes No N/A

Photo evidence (optional)

Corrective action or disposition recorded critical (required)

Document the disposition for any non-conformance, including re-test, repair, hold, or reject status.

Photo evidence captured

Attach photos of the test setup, instrument display, or any defect indication as applicable.

Final Review and Sign-Off

Inspection result accepted critical (required)

Confirm the module meets the acceptance criteria for the routine partial discharge test.

Yes No N/A

Inspector signature critical (required)

Inspector or competent person sign-off confirming the record is complete and accurate.

Review date and time

Record when the inspection record was completed and reviewed.

Get your results

Enter your email — we'll send you a PDF of your filled-out template, plus the occasional MangoScoop newsletter (templates, workflow tips, product updates). Unsubscribe anytime — link is in every email.

Email (required)

Your name (optional)

Generated with MangoApps Templates — browse 250+ free