Run NEMT Wheelchair Lift Daily Inspection — Free

Inspection Setup

Vehicle and lift identified before inspection

Record the vehicle unit number, lift make/model if available, date, and odometer or fleet identifier.

Inspection performed before passenger service critical (required)

Confirm the lift was inspected before the vehicle was placed into service for the day.

Yes No N/A

Inspector is trained and authorized to perform lift check critical (required)

Confirm the person completing the inspection is trained on the lift and vehicle procedures.

Yes No N/A

Visual Walk-Around and Platform Condition

Lift area is clear of debris, obstructions, and slip hazards critical (required)

Check the ground, threshold, and lift path for trash, fluids, ice, loose items, or other hazards.

Yes No N/A

Platform surface, edges, and non-slip finish are intact critical (required)

Inspect for cracks, bends, broken welds, missing anti-slip material, or sharp edges.

Yes No N/A

Platform gates, barriers, or retaining devices are present and undamaged critical (required)

Verify all required barriers or guards are secure, operate normally, and show no visible damage.

Yes No N/A

Lift mounting points, pins, and visible hardware are secure critical (required)

Look for missing fasteners, looseness, corrosion, or signs of abnormal wear.

Yes No N/A

Hydraulic, Electrical, and Control Function

Hydraulic system shows no visible leaks critical (required)

Inspect cylinders, hoses, fittings, and reservoir area for fluid leaks, drips, or wet residue.

Yes No N/A

Hydraulic movement is smooth and without abnormal noise critical (required)

During operation, the lift should raise and lower without jerking, binding, or unusual grinding or squealing.

Yes No N/A

Control switches and emergency stop function properly critical (required)

Verify all required controls respond correctly and the emergency stop or equivalent safety control works as intended.

Yes No N/A

Interlock prevents unsafe operation when required critical (required)

Confirm the interlock system prevents lift movement unless the vehicle is in the proper safe condition, per manufacturer procedure.

Yes No N/A

Cycle Test and Safe Operation

Lift completes a full up-and-down cycle critical (required)

Run the lift through a complete cycle from stowed to deployed and back to stowed without interruption or malfunction.

Yes No N/A

Platform remains level and stable during travel critical (required)

Observe whether the platform stays stable and does not tilt, drift, or shift unexpectedly during operation.

Yes No N/A

Safety features engage as designed during the cycle test critical (required)

Verify any required safety latches, stops, or automatic features function according to the manufacturer’s operating procedure.

Yes No N/A

Deficiencies, Out-of-Service Decision, and Sign-Off

Any deficiency or non-conformance documented

Record all observed defects, abnormal conditions, or failed checks with enough detail for maintenance action.

Vehicle removed from service if lift failed inspection critical (required)

If any critical item failed or the lift did not complete the cycle test, confirm the vehicle was taken out of service until repaired.

Yes No N/A

Inspector signature

Inspector signs to confirm the inspection was completed and the results are accurate.

Get your results

Enter your email — we'll send you a PDF of your filled-out template, plus the occasional MangoScoop newsletter (templates, workflow tips, product updates). Unsubscribe anytime — link is in every email.

Email (required)

Your name (optional)

Run: NEMT Wheelchair Lift Daily Inspection

Inspection Setup

Visual Walk-Around and Platform Condition

Hydraulic, Electrical, and Control Function

Cycle Test and Safe Operation

Deficiencies, Out-of-Service Decision, and Sign-Off

Get your results