Run Frame and Unibody Straightening Equipment Inspection — Free

Inspection Details

Inspection date and time recorded

Inspector name and role recorded

Equipment identification recorded

Record frame rack or bench ID, bay number, and any attached measuring system identifier.

Equipment has been idle for 3 months or more critical (required)

If yes, inspection must be completed by a qualified person before use.

Yes No N/A

Frame Bench and Anchoring

Frame bench surface is level, stable, and free of visible damage critical (required)

Yes No N/A

Anchors, floor mounts, and tie-down points are secure and undamaged critical (required)

Yes No N/A

Hydraulic lines, hoses, and fittings show no leaks, abrasion, or kinks critical (required)

Yes No N/A

Photo evidence (optional)

Power unit, pump, and controls operate normally critical (required)

Yes No N/A

Work area around the bench is clear of trip hazards and obstructions

Yes No N/A

Towers, Pulling Hardware, and Clamps

Pulling towers move, lock, and hold position correctly critical (required)

Yes No N/A

Chains, hooks, and pulling attachments are free of cracks, deformation, or excessive wear critical (required)

Yes No N/A

Photo evidence (optional)

Clamps and grip points are clean, aligned, and hold securely without slippage critical (required)

Yes No N/A

Fasteners, pins, and locking devices are present and functioning critical (required)

Yes No N/A

No unauthorized adapters or improvised rigging are in use critical (required)

Yes No N/A

Measuring System Accuracy

Measuring system components are present, clean, and undamaged critical (required)

Yes No N/A

Reference points, scales, and indicators are legible and not worn critical (required)

Yes No N/A

Measuring system zero check completed critical (required)

Yes No N/A

Measured deviation from reference is within manufacturer tolerance critical (required)

Record the observed deviation or calibration check result.

Measuring system calibration status is current critical (required)

Yes No N/A

Safety Devices, Documentation, and Release

Emergency stop and safety controls are accessible and functional critical (required)

Yes No N/A

Required PPE is available and being used for the inspection and planned pull critical (required)

Yes No N/A

Deficiencies identified and corrective actions documented

Equipment released for structural pulls critical (required)

Yes No N/A

Inspector signature

Get your results

Enter your email — we'll send you a PDF of your filled-out template, plus the occasional MangoScoop newsletter (templates, workflow tips, product updates). Unsubscribe anytime — link is in every email.

Email (required)

Your name (optional)

Run: Frame and Unibody Straightening Equipment Inspection

Inspection Details

Frame Bench and Anchoring

Towers, Pulling Hardware, and Clamps

Measuring System Accuracy

Safety Devices, Documentation, and Release

Get your results