Run Cord and Plug Polarity and Continuity Check - Appliance Assembly — Free

Inspection Identification

Cord set / plug assembly identifier recorded

Record the unique part number, lot number, serial number, or other traceability identifier for the cord set or plug assembly.

Inspection date and time recorded

Capture the date and time the inspection was performed.

Inspector name or ID recorded

Record the inspector's name, employee ID, or badge number.

Visual Condition and Assembly Readiness

Cord jacket free of cuts, abrasions, cracks, or exposed conductors critical (required)

Inspect the full visible length of the cord for physical damage or insulation defects.

Yes No N/A

Photo evidence (optional)

Plug and connector housing free of damage, deformation, or loose parts critical (required)

Verify the plug blades, strain relief, and housing are intact and secure.

Yes No N/A

Photo evidence (optional)

Strain relief properly seated and secure critical (required)

Confirm the cord is retained by the strain relief and cannot be pulled free by hand.

Yes No N/A

No visible contamination, scorch marks, or evidence of overheating critical (required)

Check for discoloration, burn marks, melted insulation, or other signs of thermal damage.

Yes No N/A

Photo evidence (optional)

Polarity Verification

Hot conductor continuity verified to intended plug blade critical (required)

Verify the hot conductor is mapped to the correct plug blade and intended appliance termination point.

Yes No N/A

Neutral conductor continuity verified to intended plug blade critical (required)

Verify the neutral conductor is mapped to the correct plug blade and intended appliance termination point.

Yes No N/A

Ground conductor continuity verified to grounding point critical (required)

Verify the equipment grounding conductor is continuous from the grounding pin to the intended grounding point.

Yes No N/A

No conductor reversal detected critical (required)

Confirm hot, neutral, and ground are not reversed or cross-wired.

Yes No N/A

Continuity and Meter Readings

Hot conductor resistance / continuity reading recorded critical (required)

Record the measured resistance or continuity value for the hot conductor path.

Neutral conductor resistance / continuity reading recorded critical (required)

Record the measured resistance or continuity value for the neutral conductor path.

Ground conductor resistance / continuity reading recorded critical (required)

Record the measured resistance or continuity value for the grounding conductor path.

Test instrument identification recorded

Record the multimeter or continuity tester ID, asset number, or calibration reference used for the test.

Disposition, Deficiencies, and Sign-off

Deficiencies documented when present

Record whether any defect, non-conformance, or critical item failure was identified during inspection.

Yes No N/A

Corrective action or hold status assigned for failed items

Document rework, rejection, quarantine, or other disposition for any failed cord or plug assembly.

Inspector signature

Inspector confirms the inspection results are accurate and complete.

Get your results

Enter your email — we'll send you a PDF of your filled-out template, plus the occasional MangoScoop newsletter (templates, workflow tips, product updates). Unsubscribe anytime — link is in every email.

Email (required)

Your name (optional)

Run: Cord and Plug Polarity and Continuity Check - Appliance Assembly

Inspection Identification

Visual Condition and Assembly Readiness

Polarity Verification

Continuity and Meter Readings

Disposition, Deficiencies, and Sign-off

Get your results