Run Coating Thickness DFT Verification Log - Film and Foil Converting — Free

Inspection Setup and Specification

Job, roll, or lot identification recorded critical (required)

Substrate type confirmed critical (required)

Coating specification and target DFT available at point of use critical (required)

Yes No N/A

Acceptance tolerance documented critical (required)

Measurement locations defined across web width and machine direction critical (required)

Yes No N/A

Environmental conditions suitable for measurement

Record whether temperature, humidity, and line conditions are within the site's approved measurement method.

Yes No N/A

Gauge Calibration and Verification

Gauge identification recorded critical (required)

Calibration status current critical (required)

Yes No N/A

Zero check performed before measurement critical (required)

Yes No N/A

Verification with calibration foil or reference standard completed critical (required)

Yes No N/A

Reference standard value and observed reading recorded critical (required)

Gauge method appropriate for substrate and coating system

Yes No N/A

Web Position Measurements

Drive side web position DFT critical (required)

Center web position DFT critical (required)

Operator side web position DFT critical (required)

Additional intermediate web positions measured

Note (optional)

All measured values within specification tolerance critical (required)

Yes No N/A

Process Stability and Non-Conformance

Thickness variation across web is within control limits

Yes No N/A

Any out-of-spec reading identified and contained critical (required)

Yes No N/A

Corrective action documented for any non-conformance

Documentation and Closeout

Measurement record complete and legible critical (required)

Yes No N/A

Photo evidence attached for setup or failed readings

Inspector name recorded critical (required)

Inspection date and time recorded critical (required)

Supervisor or QA review required

Yes No N/A

Get your results

Enter your email — we'll send you a PDF of your filled-out template, plus the occasional MangoScoop newsletter (templates, workflow tips, product updates). Unsubscribe anytime — link is in every email.

Email (required)

Your name (optional)

Run: Coating Thickness DFT Verification Log - Film and Foil Converting

Inspection Setup and Specification

Gauge Calibration and Verification

Web Position Measurements

Process Stability and Non-Conformance

Documentation and Closeout

Get your results