Run Bubble Emission Leak Test Record (ASTM F2096) — Free

Inspection Details

Test date and time critical (required)

Inspector name critical (required)

Lot, batch, or sample ID critical (required)

Package type critical (required)

Reference method and procedure

Identify the applicable SOP, work instruction, or ASTM F2096 reference used for the test.

Test Setup and Equipment

Test chamber or water bath clean and filled to required level critical (required)

Yes No N/A

Pressurization source connected and functioning critical (required)

Yes No N/A

Pressure gauge or readout verified against current calibration status critical (required)

Yes No N/A

Test fixture or nozzle properly sealed to package port or access point critical (required)

Yes No N/A

Test pressure setting critical (required)

Record the actual test pressure used per the approved procedure.

Dwell or observation time critical (required)

Record the time the package was held underwater while observing for continuous bubble emission.

Bubble Emission Test Observation

Package fully submerged during pressurization critical (required)

Yes No N/A

Continuous bubble emission observed from package or seal area critical (required)

Any continuous stream of bubbles indicates a gross leak and a failed result.

Yes No N/A

Leak location

If bubbles were observed, identify the approximate location such as seal edge, corner, film, port, or closure.

Leak severity

Select the observed condition during the test.

Photo evidence captured

Attach a photo of the test setup or observed defect when a leak is present.

Test result critical (required)

Pass only if no gross leak or continuous bubble emission is observed.

Disposition and Corrective Action

Failed sample segregated or identified critical (required)

Yes No N/A

Corrective action required

Yes No N/A

Disposition critical (required)

Defect or non-conformance notes

Describe the observed non-conformance, suspected root cause, or follow-up needed.

Inspector Sign-Off

Inspector signature critical (required)

Supervisor or QA review required

Use when a failed result, deviation, or non-conformance requires review by QA or a supervisor.

Yes No N/A

Get your results

Enter your email — we'll send you a PDF of your filled-out template, plus the occasional MangoScoop newsletter (templates, workflow tips, product updates). Unsubscribe anytime — link is in every email.

Email (required)

Your name (optional)

Run: Bubble Emission Leak Test Record (ASTM F2096)

Inspection Details

Test Setup and Equipment

Bubble Emission Test Observation

Disposition and Corrective Action

Inspector Sign-Off

Get your results