Templates › Inspections › SEO page

Run: Brick Compressive Strength Test Log (ASTM C67)

Log brick compressive strength test results for sampled fired brick under ASTM C67, with fields for specimen setup, individual results, averages, and complia...

Fill this out, get a PDF emailed to you. No account required. Want to run it with your team and track results? Sign up free →

Inspection Identification

Project, batch, and sample identification recorded

Record the project name, lot or batch number, sample ID, and source of the brick sample.

Inspection date and test location documented critical (required)

Enter the date and time the test was performed and the laboratory or site location.

Specified brick grade or acceptance criterion identified critical (required)

Document the required minimum compressive strength or grade basis used for acceptance, including reference to the applicable specification.

Sample Preparation and Test Setup

Sample count and specimen condition recorded critical (required)

Record the number of brick specimens tested and note whether specimens were intact, representative, and free of visible damage before testing.

Specimen dimensions measured and documented critical (required)

Record measured dimensions used for area calculation, including length, width, and height as applicable.

Testing machine identification and calibration status verified critical (required)

Document the compression testing machine ID, calibration date, and verification status before testing.

Loading surfaces and capping or bedding method documented

Record the specimen orientation, bearing surface condition, and any capping or bedding method used for the compressive strength test.

Compressive Strength Results

Individual specimen compressive strength values recorded critical (required)

Enter each specimen's calculated compressive strength result and the corresponding failure load if available.

Average compressive strength calculated critical (required)

Record the average compressive strength for the tested sample set.

Lowest specimen result documented

Record the lowest individual compressive strength result observed during the test set.

Note (optional)

Units of measure confirmed critical (required)

Select the unit used for reporting compressive strength results.

Compliance Review and Disposition

Results meet specified grade requirement critical (required)

Confirm whether the measured compressive strength results meet or exceed the specified grade requirement.

Yes No N/A

Non-conformance or deviation documented when applicable

If results do not meet the requirement, document the deficiency, affected lot, and disposition or corrective action.

Related observations recorded

Record any additional test observations relevant to the brick sample condition or test outcome.

Note (optional)

Sign-Off and Traceability

Inspector name and signature completed critical (required)

Inspector or laboratory representative signs to confirm the accuracy and completeness of the recorded results.

Reference report or supporting document attached

Attach the test report, data sheet, or supporting evidence for traceability.

Chain of custody or sample traceability noted

Document the chain of custody, receiving record, or other traceability information for the tested brick specimens.

Get your results

Enter your email — we'll send you a PDF of your filled-out template, plus the occasional MangoScoop newsletter (templates, workflow tips, product updates). Unsubscribe anytime — link is in every email.

Email (required)

Your name (optional)

Generated with MangoApps Templates — browse 250+ free