Run Bag House Dust Collector Inspection — Free

Inspection Scope and System Identification

Baghouse ID, location, and equipment tag verified

Inspection date, time, and inspector recorded

System operating status documented

Note (optional)

Applicable SOP, maintenance log, or inspection record reviewed

Yes No N/A

Collector Housing and Structural Condition

Housing, ductwork, and access doors free of visible damage, corrosion, or distortion critical (required)

Yes No N/A

Access doors, clamps, and gaskets seal properly with no visible air leakage critical (required)

Yes No N/A

Structural supports, platforms, and ladders are secure and free of defects critical (required)

Yes No N/A

Dust discharge hopper is intact, properly seated, and not leaking material critical (required)

Yes No N/A

Visible accumulation of dust on top of or around the collector is within housekeeping limits

Filter Bags, Cleaning System, and Performance

Filter bags or cartridges show no tears, holes, collapse, or excessive wear critical (required)

Yes No N/A

Cleaning cycle operates normally and at the required interval critical (required)

Yes No N/A

Differential pressure is within the acceptable operating range critical (required)

Compressed air cleaning system pressure is within specification

Exhaust air shows no visible dust plume or abnormal emissions critical (required)

Yes No N/A

Housekeeping and Dust Accumulation Control

Floors, beams, ledges, and nearby surfaces are free of hazardous dust accumulation critical (required)

Yes No N/A

Dust cleanup is performed using approved methods (e.g., vacuum or wet cleanup where permitted) critical (required)

Yes No N/A

Dust containers, drums, and disposal points are closed, labeled, and not overfilled critical (required)

Yes No N/A

Combustible Dust and Fire Protection Controls

Ignition sources are controlled in the area (hot work, smoking, open flames, and unauthorized electrical sources) critical (required)

Yes No N/A

Grounding and bonding connections are present where required and appear intact critical (required)

Yes No N/A

Explosion venting, isolation, or suppression devices are present and unobstructed where installed critical (required)

Yes No N/A

Fire extinguishers and emergency access near the collector are unobstructed and available critical (required)

Yes No N/A

Combustible dust hazard controls are documented and current

Yes No N/A

Maintenance, Safety Devices, and Follow-Up

Pressure gauges, differential pressure indicators, and alarms are readable and functioning critical (required)

Yes No N/A

Lockout-tagout provisions are available and used for maintenance access as required critical (required)

Yes No N/A

Deficiencies identified during inspection have corrective actions assigned

Yes No N/A

Inspector signature

Get your results

Enter your email — we'll send you a PDF of your filled-out template, plus the occasional MangoScoop newsletter (templates, workflow tips, product updates). Unsubscribe anytime — link is in every email.

Email (required)

Your name (optional)

Run: Bag House Dust Collector Inspection

Inspection Scope and System Identification

Collector Housing and Structural Condition

Filter Bags, Cleaning System, and Performance

Housekeeping and Dust Accumulation Control

Combustible Dust and Fire Protection Controls

Maintenance, Safety Devices, and Follow-Up

Get your results