Run Argon Gas Fill Concentration Verification Inspection — Free

Inspection Setup and Unit Identification

IGU identification recorded

Record the unit ID, job number, or traceable lot identifier for the insulating glass unit being inspected.

Target argon fill specification confirmed

Enter the specified target argon concentration for this product or order.

Note (optional)

Measurement method selected

Select the non-destructive method used for verification.

Inspection performed before shipment release critical (required)

Confirm the unit was verified prior to shipment or transfer to finished goods.

Yes No N/A

Reference specification or SOP available

Confirm the applicable product specification, work instruction, or ASTM E2649-based procedure is available to the inspector.

Yes No N/A

Measurement Conditions and Instrument Readiness

Instrument calibrated and within calibration date critical (required)

Confirm the spark emission or laser instrument is calibrated and currently within its calibration interval.

Yes No N/A

Measurement surface accessible and unobstructed critical (required)

Confirm the measurement point is accessible and free of obstructions that would prevent a valid reading.

Yes No N/A

Ambient conditions recorded

Record any relevant ambient conditions that may affect measurement quality, such as temperature, humidity, or condensation.

Glass geometry or grille interference noted

Indicate whether grille patterns, spacer geometry, coatings, or unit design may affect measurement access or reading consistency.

Yes No N/A

Unit condition suitable for testing critical (required)

Confirm the IGU is intact and suitable for non-destructive gas fill verification without visible damage that would invalidate the result.

Yes No N/A

Argon Concentration Measurement

Measured argon concentration critical (required)

Enter the measured argon concentration for the IGU.

Note (optional)

Measured concentration meets target fill requirement critical (required)

Confirm the measured concentration meets the product's required fill target or minimum acceptable threshold.

Yes No N/A

Measurement taken at required locations

Confirm readings were taken at the required location(s) or sample points defined by the procedure.

Yes No N/A

Repeat reading within acceptable variation

Confirm repeat measurements, if required by the procedure, are consistent within acceptable variation.

Yes No N/A

Reading quality acceptable

Rate the clarity and reliability of the measurement result.

Low-Fill Cause Review

Potential grille interference identified

Indicate whether grille design or placement may have contributed to a low or inconsistent reading.

Yes No N/A

Potential geometry-related fill issue identified

Indicate whether unit geometry, spacer layout, or cavity design may have contributed to the result.

Yes No N/A

Potential process drift identified

Indicate whether a process drift condition may be affecting fill performance across units or a production run.

Yes No N/A

Suspected root cause category

Select the most likely cause category when the fill is below target.

Note (optional)

Disposition and Sign-Off

Inspection result critical (required)

Select the final disposition of the unit based on the measured argon concentration and inspection findings.

Note (optional)

Corrective action documented

Describe any required rework, retest, containment, or process adjustment if the unit failed or was held.

Inspector signature

Capture the inspector's sign-off for traceability.

Get your results

Enter your email — we'll send you a PDF of your filled-out template, plus the occasional MangoScoop newsletter (templates, workflow tips, product updates). Unsubscribe anytime — link is in every email.

Email (required)

Your name (optional)

Run: Argon Gas Fill Concentration Verification Inspection

Inspection Setup and Unit Identification

Measurement Conditions and Instrument Readiness

Argon Concentration Measurement

Low-Fill Cause Review

Disposition and Sign-Off

Get your results