Tall Goods and Rigid Board Storage Safety Inspection

Inspection template for standing panels, long goods, and rigid-board storage to verify securement, stacking limits, rack condition, and tip-over controls in line with OSHA 1910.176 and applicable rack safety practices.

Inspection Setup and Area Identification

• Storage area identified and accessible for inspection
• Material types in scope documented
• Inspection conducted with area clear enough to observe securement and support conditions
• Reference standard noted
  Use OSHA 1910.176 general storage requirements and applicable rack safety procedures when evaluating securement, stacking stability, and access conditions.

Securement and Tip-Over Prevention

• Standing panels and sheet goods are secured against tipping or sliding
• Long goods are restrained by racks, stops, straps, or equivalent securement
• Freestanding stacks have stable base support and are not leaning excessively
• Top-heavy or unevenly loaded storage is absent
• Any observed unsecured tall storage documented with photo evidence

Racking, A-Frames, and Structural Condition

• Racks, A-frames, and supports are free from visible damage, bending, or deformation
• Anchors, braces, stops, and retainers are present and secure
• Load-bearing members are not overloaded or visibly stressed
• Rack or storage equipment identification and load rating are visible where applicable

Stacking Limits and Storage Arrangement

• Stack height remains within site-defined safe limits
• Materials are stacked with stable, even alignment and no significant overhang
• Heavier items are stored lower than lighter items
• Aisles and access paths adjacent to storage remain unobstructed

Housekeeping, Access, and Corrective Actions

• No debris, dunnage, or loose material is contributing to instability
• Warning controls or barriers are in place where unstable storage could be contacted by traffic or pedestrians
• Any deficiency or non-conformance is documented with corrective action assigned
• Inspector comments