Run Tall Goods and Rigid Board Storage Safety Inspection — Free

Inspection Setup and Area Identification

Storage area identified and accessible for inspection

Yes No N/A

Material types in scope documented

Inspection conducted with area clear enough to observe securement and support conditions critical (required)

Yes No N/A

Reference standard noted

Use OSHA 1910.176 general storage requirements and applicable rack safety procedures when evaluating securement, stacking stability, and access conditions.

Securement and Tip-Over Prevention

Standing panels and sheet goods are secured against tipping or sliding critical (required)

Yes No N/A

Long goods are restrained by racks, stops, straps, or equivalent securement critical (required)

Yes No N/A

Freestanding stacks have stable base support and are not leaning excessively critical (required)

Yes No N/A

Top-heavy or unevenly loaded storage is absent critical (required)

Yes No N/A

Any observed unsecured tall storage documented with photo evidence

Note (optional)

Racking, A-Frames, and Structural Condition

Racks, A-frames, and supports are free from visible damage, bending, or deformation critical (required)

Yes No N/A

Anchors, braces, stops, and retainers are present and secure critical (required)

Yes No N/A

Load-bearing members are not overloaded or visibly stressed critical (required)

Yes No N/A

Rack or storage equipment identification and load rating are visible where applicable

Yes No N/A

Stacking Limits and Storage Arrangement

Stack height remains within site-defined safe limits critical (required)

Materials are stacked with stable, even alignment and no significant overhang critical (required)

Yes No N/A

Heavier items are stored lower than lighter items

Yes No N/A

Aisles and access paths adjacent to storage remain unobstructed critical (required)

Yes No N/A

Housekeeping, Access, and Corrective Actions

No debris, dunnage, or loose material is contributing to instability

Yes No N/A

Warning controls or barriers are in place where unstable storage could be contacted by traffic or pedestrians

Yes No N/A

Any deficiency or non-conformance is documented with corrective action assigned critical (required)

Yes No N/A

Inspector comments

Get your results

Enter your email — we'll send you a PDF of your filled-out template, plus the occasional MangoScoop newsletter (templates, workflow tips, product updates). Unsubscribe anytime — link is in every email.

Email (required)

Your name (optional)

Run: Tall Goods and Rigid Board Storage Safety Inspection

Inspection Setup and Area Identification

Securement and Tip-Over Prevention

Racking, A-Frames, and Structural Condition

Stacking Limits and Storage Arrangement

Housekeeping, Access, and Corrective Actions

Get your results