Spa Hot Tub Whirlpool Daily Log

Daily inspection log for spa, hot tub, and whirlpool water quality, temperature, filtration, and bather load monitoring.

Inspection Details

• Inspection date and time recorded
  Record the date and time the daily log was completed.
• Facility, spa, or vessel identified
  Enter the specific spa, hot tub, or whirlpool location inspected.
• Inspector name and role recorded
  Identify the person completing the inspection and their role.
• Operating status documented
  Document whether the spa is open, restricted, or closed.

Water Chemistry

• Sanitizer residual within facility operating range
  Record the active sanitizer residual (for example, chlorine or bromine) in ppm.
• pH within facility operating range
  Record the measured pH of the water.
• Water clarity is acceptable
  Water must be clear enough to see the main drain or bottom per facility standard.
• Combined disinfectant or oxidation indicator checked
  Confirm any required secondary water quality indicator was checked and within range, if applicable.
• Water chemistry test method used
  Document the method used to measure water chemistry.

Temperature and Comfort

• Water temperature within approved operating range
  Record the water temperature and verify it remains within the facility's approved range.
• Temperature control system functioning
  Confirm the heater, thermostat, and temperature display are operating normally.
• Air and deck area free of excessive heat or slip hazards
  Check for unsafe surface conditions, condensation, or heat-related discomfort in the immediate area.

Filtration and Equipment

• Circulation pump operating
  Verify the circulation pump is running and water movement is visible.
• Filter system operating normally
  Confirm filters, strainers, and associated equipment are functioning without alarm or blockage.
• Skimmer, strainer, and return fittings unobstructed
  Check for visible debris, blockage, or damage at water circulation points.
• No visible leaks, unusual noise, or alarm conditions
  Inspect pumps, piping, and controls for leaks, abnormal vibration, or active alarms.

Usage and Safety

• Bather load within posted limit
  Record the number of bathers present and verify it does not exceed the posted maximum occupancy.
• Required safety signage visible and legible
  Check that posted rules, warning signs, and operating instructions are visible to users.
• Emergency stop, shutoff, or isolation controls accessible
  Verify emergency or isolation controls are accessible and not blocked.
• Visible contamination or unsafe condition observed
  Document any contamination, broken fittings, sharp edges, or other unsafe conditions.