Silica Exposure Control Plan Task Verification

Construction inspection template for field verification that OSHA Table 1 silica dust controls are implemented for each silica-generating task, including wet methods or vacuum dust collection and required respirator use where applicable.

Inspection Details

• Inspection date and time recorded
• Project, area, and specific silica-generating task identified
• Inspector is a competent person or authorized supervisor
• Applicable silica exposure control plan or SOP referenced

Task Identification and Table 1 Applicability

• Task matches an approved OSHA Table 1 silica-generating activity
• Crew is using the specified control method for this task
• Task setup matches the control method specified in the exposure control plan
• Work area boundaries and access controls are in place to limit exposure to others

Dust Control Method Verification

• Water delivery system is connected and functioning at the point of dust generation
• Visible dust is controlled during active work
• Vacuum dust collection system is attached and operating where required
• Dust collection components are intact and free of obvious damage or leaks
• Housekeeping prevents dry sweeping or uncontrolled dust accumulation

Respiratory Protection and PPE

• Respirator required by the exposure control plan or Table 1 task is being worn
• Respirator type matches the task requirement
• Respirator is clean, undamaged, and properly fitted on the worker
• Additional required PPE is being worn

Equipment Condition and Closeout

• Tool, blade, bit, or attachment is appropriate for the task and in serviceable condition
• Water supply, hoses, fittings, or vacuum hoses are free of visible damage and secure
• Deficiencies or non-conformances were identified and communicated to the responsible supervisor
• Corrective action required and documented
• Inspector signature