Pipe Spool Installation Inspection

Inspection template for verifying pipe spool installation against approved isometrics, including material verification, alignment, supports, slope, and installation readiness.

Inspection Setup and Drawing Verification

• Approved isometric drawing and latest revision available on site
• Pipe spool tag, line number, and service match the isometric
• Installation area and spool boundaries clearly identified
• Inspector verified access and work area are safe for inspection

Material and Component Verification

• Pipe material, schedule, and diameter match the isometric/specification
• Fittings, reducers, elbows, and tees match specified type and orientation
• Flanges, gaskets, and bolting are correct for service and rating
• Material identification and traceability markings are present and legible

Alignment, Elevation, and Slope

• Spool alignment matches adjacent tie-in points without visible strain
• Elevation and centerline position match the isometric within tolerance
• Pipe slope matches design requirement
• No evidence of forced fit-up, distortion, or excessive gap at joints

Supports, Hangers, and Anchors

• Pipe supports are installed at the specified locations per isometric/support detail
• Support type matches the drawing (shoe, clamp, hanger, guide, anchor, or spring support)
• Supports are plumb, level, and securely fastened to structure
• Pipe is properly seated on supports with no metal-to-metal damage or missing insulation protection

Installation Condition and Readiness

• Open ends are protected from debris and contamination
• Temporary supports, shipping braces, or installation aids are removed or identified for removal
• Required welds, fit-up, or bolt-up work is complete for the inspected scope
• Deficiencies, non-conformances, or punch list items documented with corrective actions