Dart Impact and Puncture Resistance Log

Inspection template for recording dart drop impact and puncture resistance results for plastic film samples, including sample identification, test conditions, failure mode, and pass/fail outcome for handling and distribution readiness.

Inspection Details

• Inspection date and time recorded
• Inspector name and department recorded
• Sample ID, lot number, and material description recorded
• Test objective identified as dart impact and puncture resistance verification
• Reference standard or internal SOP documented
  Record the applicable method reference, such as ASTM D1709 or an internal equivalent procedure.
• Test location and equipment ID recorded
• Calibration status verified for test equipment

Sample Preparation and Test Conditions

• Sample thickness measured and recorded
• Sample dimensions recorded
• Sample conditioning time and environment recorded
• Test temperature recorded
• Test humidity recorded
• Dart mass or impact configuration recorded
• Clamp condition and film mounting verified

Dart Impact Test Results

• Number of test drops completed
• Impact energy or height recorded
• Observed pass/fail result for dart impact test
• Failure mode observed
• Average impact resistance value recorded
• Result meets internal acceptance criteria
• Photo evidence of failed or damaged sample captured

Puncture Resistance and Handling Assessment

• Puncture resistance result recorded
• Sample remained intact during handling simulation
• Film toughness acceptable for storage and distribution
• Observed defects or anomalies noted
• Non-conformance reported if results are below specification

Review, Corrective Actions, and Sign-Off

• Corrective action or disposition documented for any failure
• Retest required
• Inspector signature
• Supervisor or quality reviewer approval