Crane Daily Pre-Use Inspection

Daily mobile crane pre-use inspection for hooks, ropes, load indicators, outriggers, and ground conditions.

Inspection Details

• Crane identification recorded
  Record crane make/model, unit number, and asset ID.
• Date and shift recorded
  Record the inspection date and shift start time.
• Inspector is a competent person or authorized operator
  Confirm the inspection is being completed by a qualified person familiar with the crane and site conditions.

Hooks, Wire Ropes, and Rigging Interface

• Hook latch present and functional
  Verify the safety latch is installed, closes fully, and prevents accidental disengagement.
• Hook shows no visible deformation, cracks, or excessive wear
  Inspect the hook body, throat, and shank for bending, twisting, cracks, or other damage.
• Wire rope has no broken wires, kinks, crushing, birdcaging, or corrosion
  Inspect all visible rope sections for damage, distortion, or deterioration.
• Wire rope reeving and spooling are correct
  Confirm rope is seated correctly on drums and sheaves with no cross-winding or improper reeving.
• Sheaves, blocks, and visible fasteners are secure and free of damage
  Check for missing pins, loose hardware, cracked sheaves, or abnormal wear.

Load Indicators, Controls, and Safety Devices

• Load moment indicator or rated capacity device functions properly
  Verify the load indicator, rated capacity limiter, or equivalent device powers on and displays normal status.
• Load chart is present and legible in the cab
  Confirm the correct load chart for the crane configuration is available and readable.
• Controls, pedals, and emergency stop operate normally
  Check that control response is smooth, labeled, and free from sticking or abnormal delay.
• Anti-two-block, limit switches, and warning alarms are functional
  Verify applicable audible/visual warnings and safety interlocks operate as intended.

Outriggers, Stabilizers, and Leveling

• Outriggers and stabilizers extend and retract smoothly
  Check for hydraulic leaks, binding, damaged cylinders, or uneven movement.
• Outrigger pads and cribbing are present, sized appropriately, and in good condition
  Confirm pads/cribbing are adequate for the load and free of cracks, splits, or instability.
• Crane is level within manufacturer limits
  Record the measured level or slope before operation.
• Outrigger area is free of obstructions and overhead hazards
  Verify there is adequate clearance for full deployment and operation.

Ground Conditions and Work Area

• Ground bearing surface is firm, stable, and suitable for crane setup
  Inspect for soft soil, voids, sinkage, washouts, trenches, or other conditions that could affect stability.
• Ground is free of slope, settlement, or conditions that exceed site limits
  Confirm the setup area will support the crane and load without unacceptable movement.
• Work area is clear of personnel and nonessential equipment
  Verify the lift zone is controlled and exclusion boundaries are established as needed.
• Overhead and nearby hazards identified
  Identify hazards present in the work area before lifting.

Corrective Actions and Sign-Off

• Deficiencies documented with corrective action
  Record all deficiencies, non-conformances, and actions taken before the crane is placed into service.
• Inspection completed and signed
  Inspector signature confirming the pre-use inspection was completed.