Run Crane Daily Pre-Use Inspection — Free

Inspection Details

Crane identification recorded

Record crane make/model, unit number, and asset ID.

Date and shift recorded

Record the inspection date and shift start time.

Inspector is a competent person or authorized operator critical (required)

Confirm the inspection is being completed by a qualified person familiar with the crane and site conditions.

Yes No N/A

Hooks, Wire Ropes, and Rigging Interface

Hook latch present and functional critical (required)

Verify the safety latch is installed, closes fully, and prevents accidental disengagement.

Yes No N/A

Hook shows no visible deformation, cracks, or excessive wear critical (required)

Inspect the hook body, throat, and shank for bending, twisting, cracks, or other damage.

Yes No N/A

Wire rope has no broken wires, kinks, crushing, birdcaging, or corrosion critical (required)

Inspect all visible rope sections for damage, distortion, or deterioration.

Yes No N/A

Wire rope reeving and spooling are correct critical (required)

Confirm rope is seated correctly on drums and sheaves with no cross-winding or improper reeving.

Yes No N/A

Sheaves, blocks, and visible fasteners are secure and free of damage

Check for missing pins, loose hardware, cracked sheaves, or abnormal wear.

Yes No N/A

Load Indicators, Controls, and Safety Devices

Load moment indicator or rated capacity device functions properly critical (required)

Verify the load indicator, rated capacity limiter, or equivalent device powers on and displays normal status.

Yes No N/A

Load chart is present and legible in the cab critical (required)

Confirm the correct load chart for the crane configuration is available and readable.

Yes No N/A

Controls, pedals, and emergency stop operate normally critical (required)

Check that control response is smooth, labeled, and free from sticking or abnormal delay.

Yes No N/A

Anti-two-block, limit switches, and warning alarms are functional critical (required)

Verify applicable audible/visual warnings and safety interlocks operate as intended.

Yes No N/A

Outriggers, Stabilizers, and Leveling

Outriggers and stabilizers extend and retract smoothly critical (required)

Check for hydraulic leaks, binding, damaged cylinders, or uneven movement.

Yes No N/A

Outrigger pads and cribbing are present, sized appropriately, and in good condition critical (required)

Confirm pads/cribbing are adequate for the load and free of cracks, splits, or instability.

Yes No N/A

Crane is level within manufacturer limits critical (required)

Record the measured level or slope before operation.

Outrigger area is free of obstructions and overhead hazards

Verify there is adequate clearance for full deployment and operation.

Yes No N/A

Ground Conditions and Work Area

Ground bearing surface is firm, stable, and suitable for crane setup critical (required)

Inspect for soft soil, voids, sinkage, washouts, trenches, or other conditions that could affect stability.

Yes No N/A

Ground is free of slope, settlement, or conditions that exceed site limits critical (required)

Confirm the setup area will support the crane and load without unacceptable movement.

Yes No N/A

Work area is clear of personnel and nonessential equipment critical (required)

Verify the lift zone is controlled and exclusion boundaries are established as needed.

Yes No N/A

Overhead and nearby hazards identified

Identify hazards present in the work area before lifting.

Note (optional)

Corrective Actions and Sign-Off

Deficiencies documented with corrective action critical (required)

Record all deficiencies, non-conformances, and actions taken before the crane is placed into service.

Inspection completed and signed critical (required)

Inspector signature confirming the pre-use inspection was completed.

Get your results

Enter your email — we'll send you a PDF of your filled-out template. We won't sign you up to anything; you can opt in to the trial from the email if you want.

Email (required)

Your name (optional)

Run: Crane Daily Pre-Use Inspection

Inspection Details

Hooks, Wire Ropes, and Rigging Interface

Load Indicators, Controls, and Safety Devices

Outriggers, Stabilizers, and Leveling

Ground Conditions and Work Area

Corrective Actions and Sign-Off

Get your results