Bag House Dust Collector Inspection

Inspection template for evaluating baghouse dust collector condition, performance, housekeeping, and combustible dust controls.

Inspection Scope and System Identification

• Baghouse ID, location, and equipment tag verified
• Inspection date, time, and inspector recorded
• System operating status documented
• Applicable SOP, maintenance log, or inspection record reviewed

Collector Housing and Structural Condition

• Housing, ductwork, and access doors free of visible damage, corrosion, or distortion
• Access doors, clamps, and gaskets seal properly with no visible air leakage
• Structural supports, platforms, and ladders are secure and free of defects
• Dust discharge hopper is intact, properly seated, and not leaking material
• Visible accumulation of dust on top of or around the collector is within housekeeping limits

Filter Bags, Cleaning System, and Performance

• Filter bags or cartridges show no tears, holes, collapse, or excessive wear
• Cleaning cycle operates normally and at the required interval
• Differential pressure is within the acceptable operating range
• Compressed air cleaning system pressure is within specification
• Exhaust air shows no visible dust plume or abnormal emissions

Housekeeping and Dust Accumulation Control

• Floors, beams, ledges, and nearby surfaces are free of hazardous dust accumulation
• Dust cleanup is performed using approved methods (e.g., vacuum or wet cleanup where permitted)
• Dust containers, drums, and disposal points are closed, labeled, and not overfilled

Combustible Dust and Fire Protection Controls

• Ignition sources are controlled in the area (hot work, smoking, open flames, and unauthorized electrical sources)
• Grounding and bonding connections are present where required and appear intact
• Explosion venting, isolation, or suppression devices are present and unobstructed where installed
• Fire extinguishers and emergency access near the collector are unobstructed and available
• Combustible dust hazard controls are documented and current

Maintenance, Safety Devices, and Follow-Up

• Pressure gauges, differential pressure indicators, and alarms are readable and functioning
• Lockout-tagout provisions are available and used for maintenance access as required
• Deficiencies identified during inspection have corrective actions assigned
• Inspector signature