Injection Molding Parameter Change Log

Records any deviation from master setup parameters during an injection molding run, including the reason, approval, and traceability details.

Run and Equipment Identification

• Date and time of change
  Record when the parameter change was made.
• Work order number
  Enter the active work order or job number.
• Machine ID
  Identify the injection molding machine used for this run.
• Mold / tool ID
  Identify the mold or tool associated with the run.
• Part number
  Enter the part number being produced.
• Shift

Master Setup Reference

• Master setup version
  Enter the approved setup revision or version number.
• Parameter category changed
  Select all parameter groups affected by the change.
• Approved by
  Enter the name or ID of the approving supervisor, engineer, or quality representative if applicable.

Parameter Change Details

• Type of change
• Primary parameter changed
  Name the specific parameter changed first.
• Master setup value
  Enter the approved baseline value from the master setup.
• New value
  Enter the adjusted value currently in use.
• Units
• Expected duration of change
  Use this to support progressive disclosure for temporary versus permanent changes.

Reason and Impact

• Reason for change
  Describe the reason for the deviation from master setup parameters.
• Observed effect after change
  Select any observed outcomes after the adjustment.
• Quality concern noted?
• Quality concern details
  Describe any defect, scrap, hold, or inspection concern related to the change.

Verification and Follow-Up

• Verified by
  Enter the name or ID of the person who verified the change.
• Verification method
• Follow-up required?
• Follow-up action
  Describe the next step, such as engineering review, parameter approval, or corrective action.
• Supporting file
  Optional upload for screenshots, setup sheet markup, inspection record, or related evidence.