Run Roll Forming Line Pre-Operation Inspection — Free

Inspection Details and Startup Authorization

Inspection date and time recorded

Line, shift, and product run identified

Setup technician or operator identified

Production authorization obtained from supervisor critical (required)

Yes No N/A

Coil Feed and Material Path

Coil is correct grade, width, thickness, and ID for the job critical (required)

Yes No N/A

Coil is centered and aligned with entry guides critical (required)

Yes No N/A

Entry guides, straightener, and feed rollers are free of damage and obstruction critical (required)

Yes No N/A

Material path is clear of scrap, tools, and loose hardware critical (required)

Yes No N/A

Coil brake / payoff tension set to prevent slack or overfeed

Yes No N/A

Roller Stations and Mechanical Condition

Roller stations are securely mounted and properly aligned critical (required)

Yes No N/A

Roller surfaces are clean, undamaged, and free of buildup critical (required)

Yes No N/A

Fasteners, shafts, and bearings show no visible looseness or abnormal wear critical (required)

Yes No N/A

Drive components are free of unusual noise, vibration, or leakage critical (required)

Yes No N/A

Guarding is installed and intact around moving roller stations critical (required)

Yes No N/A

Lubrication and Hydraulic / Pneumatic Readiness

Lubrication system reservoir level is within operating range critical (required)

Yes No N/A

Lubrication points are receiving coverage at all required stations critical (required)

Yes No N/A

No visible leaks at lubrication, hydraulic, or pneumatic lines critical (required)

Yes No N/A

Lubricant type matches the machine specification and product requirements

Yes No N/A

Cut-Off, Controls, and Safety Devices

Cut-off mechanism cycles smoothly through a dry test without binding critical (required)

Yes No N/A

Cut length setting matches the job specification critical (required)

Emergency stop buttons are accessible, labeled, and functional critical (required)

Yes No N/A

Control panel indicators show normal status with no active fault alarms

Yes No N/A

First-Piece Profile and Final Startup Sign-Off

First-piece profile matches approved sample or drawing critical (required)

Yes No N/A

First-piece cut length is within specification critical (required)

Yes No N/A

Any setup adjustments or deficiencies documented before release

Inspector signature critical (required)

Get your results

Enter your email — we'll send you a PDF of your filled-out template, plus the occasional MangoScoop newsletter (templates, workflow tips, product updates). Unsubscribe anytime — link is in every email.

Email (required)

Your name (optional)

Run: Roll Forming Line Pre-Operation Inspection

Inspection Details and Startup Authorization

Coil Feed and Material Path

Roller Stations and Mechanical Condition

Lubrication and Hydraulic / Pneumatic Readiness

Cut-Off, Controls, and Safety Devices

First-Piece Profile and Final Startup Sign-Off

Get your results