Run Mold Tooling Pre-Run Inspection — Free

Mold Identification and Setup

Mold ID matches the production order and setup sheet critical (required)

Yes No N/A

Mold is fully seated and aligned in the press critical (required)

Yes No N/A

All locating rings, dowels, and support points are engaged critical (required)

Yes No N/A

Mold surfaces are clean and free of debris, rust, and residue

Yes No N/A

Cooling Lines and Water Connections

Cooling lines are connected to the correct inlets and outlets critical (required)

Yes No N/A

Hoses and fittings are secure with no kinks, abrasion, or strain critical (required)

Yes No N/A

No visible water leaks at mold, hose, manifold, or quick-connect points critical (required)

Yes No N/A

Cooling flow is established and within the expected operating range critical (required)

Yes No N/A

Clamps, Fasteners, and Hardware

All clamps are installed, tight, and properly positioned critical (required)

Yes No N/A

Bolts, screws, and retaining hardware are present and secure critical (required)

Yes No N/A

No loose hardware, missing fasteners, or visible damage is present

Yes No N/A

Clamp area is clear of obstructions and pinch hazards critical (required)

Yes No N/A

Ejector System

Ejector pins, plates, and return mechanisms move freely without binding critical (required)

Yes No N/A

Ejector stroke and return position are correct for the setup critical (required)

Yes No N/A

No visible damage, galling, or excessive wear on ejector components

Yes No N/A

Ejector safety interlocks and machine settings are confirmed per setup sheet critical (required)

Yes No N/A

Final Pre-Run Readiness

All identified deficiencies have been corrected or escalated critical (required)

Yes No N/A

Work area is clear, dry, and free of trip or slip hazards critical (required)

Yes No N/A

Machine, mold, and startup parameters are approved for production start critical (required)

Yes No N/A

Inspector sign-off completed critical (required)

Get your results

Enter your email — we'll send you a PDF of your filled-out template, plus the occasional MangoScoop newsletter (templates, workflow tips, product updates). Unsubscribe anytime — link is in every email.

Email (required)

Your name (optional)

Run: Mold Tooling Pre-Run Inspection

Mold Identification and Setup

Cooling Lines and Water Connections

Clamps, Fasteners, and Hardware

Ejector System

Final Pre-Run Readiness

Get your results