Run Masonry Quality Control Inspection — Free

Inspection Setup and Scope

Project, location, and masonry scope identified

Record the building/area, wall type, and scope of masonry work being inspected.

Applicable drawings, specifications, and approved submittals available critical (required)

Yes No N/A

Inspection stage verified

Select the current inspection stage.

Weather conditions suitable for masonry work

Verify conditions are suitable for the work being inspected, including protection from adverse weather as required by project procedures.

Yes No N/A

Masonry Units and Materials

Masonry units match approved type, size, and appearance critical (required)

Yes No N/A

Units are free from visible damage, contamination, or excessive chips

Yes No N/A

Material storage protects units and accessories from moisture and contamination

Yes No N/A

Mortar materials and mix proportions verified critical (required)

Yes No N/A

Grout materials and admixtures match approved submittals critical (required)

Yes No N/A

Reinforcement type, size, and grade match approved documents critical (required)

Yes No N/A

Mortar Joints and Workmanship

Bed joints are fully filled and consistent critical (required)

Yes No N/A

Head joints are fully filled and properly tooled critical (required)

Yes No N/A

Joint thickness is within project tolerance

Measure representative mortar joint thickness.

Mortar joints are clean, uniform, and free of excessive voids

Yes No N/A

Bond pattern and coursing match approved layout

Yes No N/A

Movement joints and sealant locations are installed per drawings critical (required)

Yes No N/A

Grout and Reinforcement Installation

Reinforcement is placed at specified locations and spacing critical (required)

Yes No N/A

Reinforcement is properly supported and has required cover critical (required)

Yes No N/A

Lap splices, hooks, and anchorage match approved details critical (required)

Yes No N/A

Grout placement verified in specified cells or cavities critical (required)

Yes No N/A

Grout consolidation and fill are adequate critical (required)

Yes No N/A

Grout lift height and pour sequence comply with specification

Yes No N/A

Dimensions, Alignment, and Tolerances

Wall plumbness measured within tolerance

Record measured plumb deviation over the specified reference length.

Wall alignment and straightness are within tolerance

Record measured deviation from line or straightedge.

Openings, embeds, and penetrations are located per drawings critical (required)

Yes No N/A

Jambs, corners, and interfaces are properly formed

Yes No N/A

Surface finish and visible workmanship meet project quality requirements

Non-Conformance, Corrective Action, and Sign-Off

Deficiencies and non-conformances documented

Select all observed deficiency categories.

Note (optional)

Corrective action assigned and due date recorded

Inspector signature critical (required)

Get your results

Enter your email — we'll send you a PDF of your filled-out template, plus the occasional MangoScoop newsletter (templates, workflow tips, product updates). Unsubscribe anytime — link is in every email.

Email (required)

Your name (optional)

Run: Masonry Quality Control Inspection

Inspection Setup and Scope

Masonry Units and Materials

Mortar Joints and Workmanship

Grout and Reinforcement Installation

Dimensions, Alignment, and Tolerances

Non-Conformance, Corrective Action, and Sign-Off

Get your results