Run Laminated Glass Interlayer Inspection — Free

Inspection Details

Panel identification recorded

Record panel ID, batch/lot number, size, and production date.

Inspection stage confirmed

Select the point in the process where the inspection was performed.

Reference standard verified

Confirm the inspection is being performed against ASTM C1172 and the applicable internal acceptance criteria.

Inspector and date recorded

Capture the inspection timestamp.

Product type confirmed as laminated glass critical (required)

Verify the item under inspection is laminated glass and not monolithic glass or another glazing product.

Yes No N/A

Surface and Interlayer Defects

Interlayer bubbles present within acceptable limit critical (required)

Inspect both faces under normal and oblique lighting for visible bubbles, blisters, or trapped air in the interlayer.

Yes No N/A

Photo evidence (optional)

Delamination observed at any location critical (required)

Check for separation between glass and interlayer, especially near edges, corners, and stress points.

Yes No N/A

Photo evidence (optional)

Interlayer contamination visible critical (required)

Inspect for dust, foreign particles, haze, streaks, or embedded contamination within the laminate.

Yes No N/A

Photo evidence (optional)

Surface scratches, chips, or optical defects within tolerance

Check for scratches, chips, distortion, or other visible defects that may affect safety or appearance.

Yes No N/A

Photo evidence (optional)

Edge Quality and Seal Integrity

Edge quality meets acceptance criteria critical (required)

Inspect exposed and concealed edges for chips, cracks, uneven trimming, and edge damage.

Yes No N/A

Photo evidence (optional)

Edge seal is continuous and intact critical (required)

Verify the edge seal shows no breaks, voids, lifting, or visible pathways for moisture ingress.

Yes No N/A

Photo evidence (optional)

Edge moisture, clouding, or discoloration present critical (required)

Check for signs of moisture ingress, fogging, clouding, or discoloration at the laminate edge.

Yes No N/A

Photo evidence (optional)

Edge finish uniform across panel

Rate the overall consistency of edge finish and workmanship.

Documentation and Disposition

Non-conformances documented

Select all defect categories observed during inspection.

Note (optional)

Corrective action assigned

Document rework, hold, scrap, or escalation actions taken for any failed item.

Disposition selected

Choose the final disposition for the inspected panel.

Photo evidence attached for defects

Attach photos showing any observed defects, especially bubbles, delamination, contamination, or edge damage.

Get your results

Enter your email — we'll send you a PDF of your filled-out template, plus the occasional MangoScoop newsletter (templates, workflow tips, product updates). Unsubscribe anytime — link is in every email.

Email (required)

Your name (optional)

Run: Laminated Glass Interlayer Inspection

Inspection Details

Surface and Interlayer Defects

Edge Quality and Seal Integrity

Documentation and Disposition

Get your results