Templates › Inspections › SEO page

Run: CNC Machine Daily Pre-Op Inspection

A daily pre-op inspection for CNC machines that checks guards, coolant, lubrication, tooling, offsets, and setup readiness before the first cycle. Use it to ...

Fill this out, get a PDF emailed to you. No account required. Want to run it with your team and track results? Sign up free →

Machine Safety and Guards

Chuck guard and other machine guards are installed, closed, and undamaged critical (required)

Confirm all required guards are in place and functioning. Do not start the machine if a guard is missing, bypassed, or damaged.

Yes No N/A

Emergency stop and machine controls are accessible and unobstructed critical (required)

Verify the E-stop and primary controls can be reached without obstruction and are not damaged.

Yes No N/A

Work area around the machine is clear of chips, tools, and trip hazards

Check the immediate area for loose tools, debris, coolant spills, or other obstructions that could affect safe operation.

Yes No N/A

Coolant and Lubrication

Coolant level is within the acceptable operating range critical (required)

Verify coolant is at the proper level for the machine and operation. Add coolant if below the minimum operating level.

Coolant condition is acceptable and free of visible contamination

Look for excessive tramp oil, foul odor, discoloration, foam, or visible contamination that could affect machining or tool life.

Yes No N/A

Way oil or automatic lubrication system is at the proper level critical (required)

Confirm way oil reservoir or lube system is within the acceptable operating range and there are no obvious leaks.

Yes No N/A

Tooling and Offsets

Tool offsets match the current setup sheet or program requirements critical (required)

Confirm tool length, diameter, wear, and work offsets are correct for the loaded job and have been verified after any tool change.

Yes No N/A

Loaded tools are secure, undamaged, and appropriate for the operation

Inspect the toolholders and cutting tools for looseness, wear, cracks, or incorrect tooling for the job.

Yes No N/A

Workholding and part setup are secure critical (required)

Verify the vise, chuck, fixture, or clamps are tight and the part is properly seated before starting the cycle.

Yes No N/A

Machine Readiness

Machine power-on status and alarms are clear critical (required)

Verify the machine powers up normally and there are no active alarms preventing safe operation.

Yes No N/A

Program, part number, and revision match the work order

Confirm the correct CNC program and job documentation are loaded for the current production run.

Yes No N/A

Operator notes

Record any abnormalities, adjustments made, or follow-up actions needed before production starts.

Get your results

Enter your email — we'll send you a PDF of your filled-out template, plus the occasional MangoScoop newsletter (templates, workflow tips, product updates). Unsubscribe anytime — link is in every email.

Email (required)

Your name (optional)

Generated with MangoApps Templates — browse 250+ free