Strapping Tension Verification Record

Inspection record for verifying strap tension, joint strength, and load securement on banding and strapping operations to confirm loads are secured to specification.

Inspection Details

• Inspection date and time recorded
• Inspector name and role recorded
• Work order, shipment, or batch identifier recorded
• Load type identified
• Inspection standard or SOP referenced
  Enter the internal specification, SOP, or customer requirement used to verify strap tension and securement.
• Inspection location recorded
• Photo evidence attached for the inspected load

Strap and Material Condition

• Strap type matches specification
• Strap is free of cuts, fraying, cracks, rust, or deformation
• Strap width and grade match the load requirement
• Protective edge guards or corner protection installed where needed
• Anchor points, buckles, seals, or clamps are undamaged and suitable for use

Tension and Joint Strength Verification

• Measured strap tension
  Record the measured tension applied to the strap using the approved tensioning method or gauge.
• Measured tension meets specified target range
  Confirm the measured tension is within the load-specific specification or SOP target.
• Joint, seal, weld, or buckle shows no slippage or separation
• Joint strength verified against required method

Load Securement and Stability

• Load is stable and does not shift during inspection
• Straps are positioned correctly across the load
  Verify strap placement follows the approved pattern, spacing, and orientation for the load type.
• Number of straps applied matches specification
• Load edges are protected from strap damage or cutting
• No visible gaps, looseness, or rebound indicates inadequate securement

Final Verification and Corrective Action

• Inspection result
• Corrective action required for any deficiency or non-conformance
• Inspector signature