Purlin and Girt Punching Dimensional Check

Inspection template for verifying punched hole pattern, lap, and overall length on cold-formed Z and C purlins and girts against the print before shipment.

Inspection Identification

• Job number / work order recorded
• Part type identified as Z or C purlin / girt
• Approved print / fabrication drawing available at station
• Revision level matches traveler / job packet

Part Setup and Identification

• Part marked with correct part number and orientation
• Material size and profile match the print
• Punch direction and handedness match the print
• Part is free of distortion that would affect measurement

Hole Pattern Verification

• Hole count matches the print
• Hole pattern location matches the print
• Hole spacing within tolerance
• Hole edge distance within tolerance
• Hole diameter matches the print
• No missing, extra, or mispunched holes observed

Lap and Length Verification

• Lap length matches the print
• Lap hole pattern aligns with mating part requirement
• Overall part length matches the print
• End cuts and punched ends are consistent with the print

Punch Quality and Non-Conformance Review

• Punch burrs, tearing, or deformation do not affect fit-up
• No cracking, elongation, or ovality at punched holes
• Any dimensional non-conformance documented and segregated
• Inspector notes and disposition recorded