Eyewash + Safety Shower Weekly Test

ANSI Z358.1 weekly eyewash and safety shower flush test. Required for all units within 10 sec travel of corrosive chemicals.

Inspection Scope and Location

• Unit is in an area with corrosive chemicals and within 10 seconds travel of the hazard
  Verify the eyewash or safety shower serves a location where corrosive chemicals are present and the unit is positioned for immediate access.
• Access path is unobstructed and clearly visible
  Verify the route to the unit is clear of stored materials, equipment, and temporary obstructions.
• Unit identification signage is present and legible
  Confirm the eyewash or shower is marked so it can be quickly located in an emergency.

Eyewash Station Test

• Eyewash activates immediately and flows continuously
  Verify the eyewash starts promptly and maintains continuous flow during the test.
• Water flow is adequate and reaches both eyes evenly
  Confirm the flushing pattern is balanced and sufficient for emergency use.
• Water is clear and free of visible contamination
  Check that the flushing fluid does not contain rust, sediment, or other visible contamination.
• Protective caps or dust covers function properly and do not obstruct activation
  Verify any caps or covers move as intended and do not prevent immediate use.

Safety Shower Test

• Safety shower activates immediately and flows continuously
  Verify the shower starts promptly and maintains continuous flow during the test.
• Shower spray pattern is centered and provides full-body coverage
  Confirm the spray pattern is distributed appropriately for emergency drenching.
• Activation handle or pull rod is accessible and unobstructed
  Verify the activation mechanism can be reached and operated without delay.
• Water is clear and free of visible contamination
  Check that the flushing fluid does not contain rust, sediment, or other visible contamination.

Documentation and Closeout

• Weekly test date and time recorded
  Document when the inspection was performed.
• Deficiencies and corrective actions documented
  Record any non-conformance, maintenance issue, or follow-up required.
• Inspector name and signature completed
  Capture the inspector's sign-off for the weekly test.