Die Stamping Pre-Run Inspection

Pre-run inspection for die stamping operations covering press setup, tonnage, shut height, feed line guards, and material readiness before production starts.

Press Setup Verification

• Press is isolated and lockout-tagout is cleared only after setup verification
• Die and tooling are installed, secured, and aligned to the job specification
• Press settings match the current job traveler or setup sheet
• Shut height is set to the specified value

Tonnage and Mechanical Readiness

• Required tonnage is within press capacity for the job
• Clutch, brake, and emergency stop controls function as intended
• No abnormal noise, vibration, leaks, or loose components are present

Safety Guards and Feed Line Protection

• Point-of-operation guards or safeguarding devices are in place and functional
• Feed line guards, barriers, and pinch-point protection are installed
• Light curtains, interlocks, or presence-sensing devices are clean and operational
• Guarding does not interfere with safe material feed or die clearance

Material Readiness and Feed Alignment

• Correct material type, thickness, and coil/blank specification are staged
• Material is free of visible damage, excessive burrs, rust, or contamination
• Feed alignment and entry path are set to prevent skew, jam, or misfeed

Pre-Run Sign-Off

• Area is clear of tools, loose parts, and non-essential personnel
• Operator confirms the press is ready for first-piece production
• Supervisor or authorized lead has reviewed and approved the setup