Compounded Sterile Preparation Garbing and Hand Hygiene Verification

Inspection template to verify sterile compounding personnel demonstrate proper garbing sequence, hand hygiene technique, and competency before entering controlled compounding areas.

Inspection Setup and Scope

• Inspector confirms personnel identity and competency assessment scope
• Assessment performed using current approved garbing and hand hygiene SOP
• Required supplies and PPE available for full garbing sequence

Hand Hygiene Technique

• Hands and forearms washed or disinfected using approved method before garbing
• Fingernails are clean, short, and free of nail polish or artificial nails
• Hand hygiene technique covers all surfaces, including between fingers and thumbs
• Hands remain free from contamination after hygiene step and before donning sterile items

Garbing Sequence and PPE

• Garbing sequence follows approved order without contamination events
• Head and facial hair fully covered as required by procedure
• Face mask worn correctly and covers nose and mouth throughout garbing
• Gown or coverall fully donned without touching exterior contaminated surfaces
• Sterile gloves donned correctly and extend over gown cuffs

Aseptic Behavior and Contamination Control

• Personnel avoids touching face, hair, clothing, or non-sterile surfaces after garbing
• Personnel demonstrates awareness of contamination risks and corrects observed deficiencies immediately
• No jewelry, watches, or prohibited personal items present during garbing
• Inspector observed no non-conformance requiring immediate retraining

Verification and Documentation

• Personnel competency verified as satisfactory for sterile compounding access
• Corrective action or retraining documented for any deficiency
• Inspector signature captured